Assembly: Head
Place head assembly onto notched end of tube without connector. Align snap area on rear of head assembly collar with the notch and catch on tube. Slide the head assembly down onto tube and press down firmly. You will feel a definite click when seated properly, and the head assembly will not turn.
head assembly
snap
notched
end tube without
connector
Operation | Down: Oscillate | Up: Stationary |
|
|
Oscillation: Push down oscillation knob on motor housing to make fan head move from side to side.
Tilting: This fan is equipped with a
1. Place one hand on the pole just under the fan neck.
2. Place other hand on top of fan.
Assembly: Blade & Grill
rear | blade | rear grill |
motor | ||
grill |
|
|
| fan |
|
| spinner |
|
| plastic nut |
|
1. Tilt fan head back. | 2. Align triangular "∆ " cut in the rear grill | |
Put rear grill on motor. | with triangular post on top of front | |
|
| motor cover. Fully seat rear grill and se- |
|
| cure with plastic nut, turning clockwise. |
ornament |
tabs |
pin |
slots |
groove |
3. Slide blade onto motor shaft. | 4. Install ornament into front grill. |
(Align groove on blade hub with | Insert tabs into rectangular slots. |
pin on motor shaft.) | Snap into place. |
To secure blade, screw fan spinner onto shaft counterclockwise until tight on blade hub.
3. Gently push or pull the fan head until it is in the desired position.
Note: The ratchet assembly on the 16" Deluxe Ped- estal Fan with thermostat is designed for positive lock positioning. Therefore, when adjusting the fan angle, you will hear a clicking sound. This is normal.
Speed: Control fan speed with fan speed dial at far right of body.
Thermostat: Adjust the thermostat dial so that the fan cools to a comfortable level. The 16" Deluxe Pedestal Fan thermostat will automatically turn the fan off and on as the room temperature changes.
less light: warmer | 16" Deluxe Pedestal Fan |
thermostat dial | |
| fan speed dial |
more light: cooler | (lighted number indicates fan speed) |
|
ornament | front grill |
|
g |
| g |
|
| |
| tab | snaps |
|
| |
|
| snaps |
tab | notch | tab |
| ||
|
|
5.With fan head in upright position, align ornament of front grill so it is horizontal. Insert bottom of front grill into plastic rear grill. Tab at the bottom of plastic rear grill should fit over notch on front grill. Snap front grill into rear grill beginning at the bottom and working up both sides. Note: No grill clips are needed for assembly.
| g is a trademark of the General Electric |
|
| Company used under license by |
|
106670 |
|
|
|
| |
|
|
|
New 3/01 2085341 Printed in USA | 2 |
|