PULL STRAIGHT OUT

HOW TO OPERATE YOUR DRYER

WARNING—To reduce the risk of fire, electric shock, or injury to persons when using your appliance, read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.

OFF

10 MIN

 

 

 

*

=

ENERGY PREFERRED

Auto -

 

OFF

MORE

 

 

 

6

 

 

 

 

AUTOMATIC SETTING

 

LESS

DRY

 

 

Regular

Permanent

 

 

 

 

 

 

 

DRY

* NORMAL

Auto-

 

 

 

 

 

 

Regular

 

 

 

 

 

 

 

 

 

 

LESS

Perm Press

 

Press

WARM

 

MED

 

 

PUSH TO

 

NORMAL

*

 

DRY

 

COLD

 

 

 

 

 

 

 

 

 

 

COLD

HOT

SMALL

LARGE

 

 

START DRYER

 

 

 

 

 

COOL

 

 

COLD

COLD

 

 

 

 

 

 

MORE

 

 

 

DOWN

 

LIGHT SOIL - 8

 

 

 

 

 

 

 

 

DRY

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

NORMAL - 10

 

 

 

 

 

 

 

 

OFF

 

 

 

OFF

 

HEAVY - 12 MIN

COOL DOWN

 

 

 

 

 

 

 

 

 

 

 

 

RINSE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Spacemaker Laundry

 

 

 

 

10 MIN

 

 

 

50 MIN

 

 

 

 

 

 

 

 

 

 

 

 

 

NORMAL

 

 

OFF

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Air

20

 

40

 

 

PULL KNOB TO START

6 MIN

WASHRINSE Temp

Load Size

 

 

Start

 

 

 

PUSH TO STOP

4

 

 

 

 

 

30

Timed

= RINSE = SPIN

Delicates

 

 

 

 

 

 

Fluff

 

OFF

 

 

 

 

 

 

 

 

 

 

20 DE-WRINKLE

 

 

 

 

 

 

 

 

 

 

 

 

 

10

 

 

21

See How to Operate Your Washer section for the above Washer controls.

Check the Lint Filter

Clean the lint filter each time the dryer is used. Always be sure the lint filter is in place.

WARNING—Do not run the dryer with the lint screen loose, damaged, blocked or missing. Doing so can cause overheating, damage fabrics and be a fire hazard.

The lint screen is located inside the dryer drum, on the back wall.

To clean:

1. Use the finger holes to pull the lint screen straight out.

2. Lightly squeeze the body,

as shown while pulling the cover off.

3.ROLL lint off the screen with your fingers. Do not rinse or wash the screen.

4.Replace the cover on the body of the lint screen.

5.Before replacing the lint screen, remove any lint from the wire mesh on the back wall (behind the lint screen).

6.Push the lint screen straight back until it snaps into place.

SQUEEZE BODY; PULL COVER OFF

Sort and Load the Clothes

Good sorting for the dryer begins at the washer. Generally, if clothes are sorted right for washing, they’re sorted right for drying. See the How to Sort Clothes section.

If you do mix various types of fabrics in your load, set the controls for the lighter-weight fabrics and remove when dry. Reset controls for the remaining heavier fabrics.

Set the Controls

See the Suggested Fabric and Drying Selections guide.

1Cycle Selector.

Turn the Cycle Selector to the desired cycle setting. The selector may be turned in either direction.

2Start Button.

Press the Start button to start the dryer. (Opening the door during operation stops the dryer. To restart, close the door and press the Start button.)

NOTE: Drying times will vary according to the type of heat used (electric, natural gas or LP gas), size of load, types of fabrics, wetness of clothes and condition of exhaust ducts.

14