8
Code Search
If your device does not respond after you have
tried all the codes for your brand, or if your brand is
not listed, try searching for your code by following
these steps.
1. Manually turn on the device (TV, DVD, etc.) to
be controlled.
2. Press and hold the SETUP button until
the red indicator stays on, then release
the SETUP button.
3. Press and quickly release the desired
mode button (TV, DVD, etc.). The red
indicator blinks off once.
4. Press the CHANNEL UP button
repeatedly (up to 300 times) until the
device to be controlled changes
channel. The red indicator blinks
off with each button press. If you
accidentally overshoot the code
required, press the CHANNEL
Most users will store DVD codes under the DVD
button, Cable codes under CABLE, etc. If (for
example) you want to store a DVD code under
CABLE,rstfollowtheprocedureforDirectCodeEntry
(page 8) and press CABLE in step 2 of Direct Code
Entry, then enter ANY DVD code in step 3 of Direct Code
Entry. Then follow the steps above for Code Search.
Note: If the device does not have a CHANNEL UP
button, use PLAY (DVD only) or POWER instead.
Code Search starts from the currently stored three digit
numberunderthatmode.Sometimestherstcode
that “works” with your device may only allow limited
functionality (e.g. the MENU button might not work).
There may be a code that performs more functions.
Continue the code search process until the best code is
found.
DOWN button to backtrack through the library
until the device changes channel. Pressing
CHANNEL UP changes direction to forward
again.
5. Press and release ENTER to install the code.