Installing the Phone | GE 25203 guide

Connections and Setup

Installing the Phone

1.Choose an area near an electrical outlet and telephone wall jack. Your phone should be placed on a level surface, such as a table top or desk.

2.Install 4 AAA-size alkaline batteries (not included) for back up power in the event of a power failure.

CAUTION: Unit will not work if electrical power fails and batteries are depleted or not installed. Therefore it is important that you replace them when “REPLACE BATTERY” shows in display in order to maintain unit operation. As a precaution, you may want to write down any stored information you do not want erased.

•Open the battery compartment door located on the bottom of the phone by inserting a flathead screw driver into the battery door latch area and gently tilting the screw driver away from the battery door to release the latch.

•Insert the batteries as shown on the diagram inside the battery compartment.

•Snap the battery compartment door back into place.

IMPORTANT: If you are not going to use the telephone for more than 30 days, remove the batteries because they can leak and damage the unit.

3.Connect the AC power adaptor to an electrical outlet and the plug connector to the back of the base.

Image 9

GE 25203 manual Installing the Phone, Snap the battery compartment door back into place

Contents

Model Equipment Approval Information Important Information Licensing Interference InformationHearing Aid Compatibility FCC RF Radiation Exposure Statement Table of Contents Caller ID Telephone OperationMemory General Product Care Introduction Introduction Installation Connections and SetupParts Checklist Important Installation Information Vol +/- buttons Base Layout Snap the battery compartment door back into place Installing the Phone Connect the telephone line cords Attaching the Desktop Pedestal Wall Mounting the Phone Data Port Manually Setting the Date and Time Programming the TelephoneDisplay Language Hour Format Flash Time Local Area Code Call Alert Tone Regional Area Codes Restoring the Defaults Voice Mail Access Codes Telephone Operation Telephone OperationMaking Calls with the Handset Making Calls with the Speakerphone Receiving Calls with the Handset Switching Between the Speakerphone, Handset, and HeadsetReceiving Calls with the Speakerphone Receiving Calls with the Optional Headset Call Timer Pre-Dialing Telephone NumbersMute Hold VolumeFlash Redial Do Not Disturb ConferenceTo connect with two calls To keep both parties on-line but talk to one party Voice Messaging Caller ID CID Caller IDSummary Screen Receiving and Storing CID Records Saving CID Records to Memory/Phone Directory Memory Reviewing CID RecordsDeleting a CID Record Deleting All CID Records Call Waiting Caller ID Direct Access Memory & Directory Memory MemoryStoring a Name and Number in Memory Changing a Stored Name or Number Reviewing Stored Names & NumbersStoring the Last Number Dialed Storing a Pause Chain Dialing Dialing a Stored Number Deleting a One-Touch Memory Deleting a Directory MemoryDeleting All Directory Memory Display Messages Other Information Troubleshooting Guide General Product Care Thomson Inc Manager, Consumer Relations Box Indianapolis, Warranty Assistance Limited Warranty How state law relates to this warranty Limitation of WarrantyProduct Registration If you purchased your product outside the USA Accessory Information Index Index Thomson Inc