GE 681131689564 warranty Using Your Food Processor, How to Slice or Shred

Parts and Features

1.Shredding Disc

2.Slicing Disc

3.Chopping Blade

4.Dough Blade

5.Disc Stem

6.Food Pusher

7.Working Bowl Cover and Feed Tube

8.Working Bowl

9.Base

10.Spatula

Using Your Food Processor

NOTE ABOUT USAGE: Do not attempt to chop ice in this Food Processor; it will damage the Bowl and dull the Chopping Blade. This unit will not whip cream, beat egg whites to a desirable volume, grind coffee beans or spices with a high oil content, or slice or shred hard-cooked eggs, marshmallows, or soft cheeses. When preparing ingredients to make dough, do not exceed the recommended amounts to yield 1 loaf of bread. Exceeding the recommended amount will cause the unit to overheat when the dough blades are in use.

IMPORTANT: For your protection, this unit has an Interlock System so the processor won’t operate unless the Bowl is locked onto the Base and the Cover is correctly locked onto the Bowl. Be sure the Bowl Handle is turned fully onto the Base so that the Handle lines up over the Signal Light. Do not attempt to operate the unit without the Cover being correctly in place. Be sure the Base is on a flat, dry, clean surface before you begin processing.

How to Slice or Shred

1. Place the Bowl over the Center Post in the Base	(A)
with the Handle at the left . Turn the Bowl towards
the right until it drops down into place. Snap the
Bowl in so that the Handle lines up straight over
the Signal Light; be sure it locks into place (A).

2.Slide the Disc Stem onto the Center Post in the Bowl. Carefully grasp the Slice or Shred Disc (they are sharp!) and push it down onto the Disc Stem.

3.Place the Cover onto the Bowl so that the Food Chute is just to the right of the Bowl Handle. Twist the Food Chute/Cover toward LOCK until you hear it click into place (B).

4. Plug the cord into an electrical outlet. Use the	(B)
Food Guide to help you prepare food for slice/shred
Processing. Fill the Food Chute with food and position
The Pusher over the food

5.Press down lightly but firmly on the Food Pusher while pressing the Pulse (or press ON for continuous process).

6.After processing food, release the Pulse, or if you were using continuous ON, press OFF. Allow the Disc to stop rotating. Twist the Food Chute/Cover toward UNLOCK to remove the Cover.

7.Grasp the Disc and lift out. Carefully pull out the Disc Stem, unlock the Bowl by turning the Handle to the left, and lift the Bowl off.

4 5