OPERATION
Tip: Operate the blender for only as long as needed to reach the right consistency. Preferably operate for a few seconds at a time. Press the power ON/OFF button (1) once the right consistency is reached.
Blending with countdown timer
The blender can be set with a time between 0:10 seconds and 3:00 minutes.
• Press the power ON/OFF button (1) to switch on the blender.
•Press start/stop button (3) to start operation. The LCD display (2) stops blinking
| blend and 12. The blender starts with default speed 12. |
| |
• | Press | up (6) while the blender is running to set the speed to the lowest setting 1. | |
• | Press | down (8) to decrease the speed stepwise, as often as | down (8) is |
| pressed. |
|
|
•Press timer button (11) to set the time for which the blender should be activated. The LCD display (2) blinks timer.
•The LCD display blinks timer and the default time of 1:00 minute. The blend and speed 12 indicator stop blinking.
• Press | up (6) or down (8) button to adjust the time up or down in 10 seconds |
increments or decrements. | |
Notes • | The time entry stops after 5 seconds. If button is not pressed, the blender |
| goes back to speed setting mode. Press timer button (11) again, to enter |
| time entry mode. |
•The blender is not required to run in order to set the timer. It can be set in stop mode.
•The timer mode is only active after pressing timer button (11). After the countdown cycle is completed, the timer indicator and time will turn off.
• Press and hold the up (6) or down (8) button to set time or speed successively.
•Press start/stop button (3) to start operation. The LCD display (2) shows the set time
| as countdown. |
| |
• | Press | up (6) or | down (8) during countdown cycle to adjust the speed in |
| operation. |
| |
• | Press timer button (11) during countdown cycle and adjust the time with up (6) | ||
| or | down (8) while in operation. | |
