GE 840165700 manual Caring for Your Iron, Soleplate, Self-Cleanon selected models

840165700 Ev02 5/1/07 4:05 PM Page 5

CARING FOR YOUR IRON

Iron

1.The water tank of your iron should be emptied after each use. Turn Temperature Control Dial to OFF ( O ). Unplug the iron and hold over a sink. Slowly tilt pointed end of iron down over sink. Water will run out of water tank opening.

2.After iron has completely cooled, fully retract cord into iron or loop cord loosely around iron, as applicable, and store in an upright position. NOTICE: Do not store iron laying flat on soleplate.

Soleplate

1.Never iron over zippers, pins, metal rivets, or snaps, as these may scratch the soleplate.

2.To clean occasional build-up on the soleplate, wipe with a sudsy cloth. Do not use abrasive cleansers or metal scouring pads.

3.Always store iron upright in the heel rest position.

Self-Clean(on selected models)

To keep the steam vents clear of any build-up, follow these instructions each time you iron using steam.

1.Turn Temperature Control Dial to OFF ( O ) and set Adjustable Steam Switch to Dry Iron O. Fill iron with water to 1⁄2 of its maximum capacity.

2.Turn Temperature Control Dial to Linen setting and let iron heat for 2 minutes. Keep Adjustable Steam Switch on Dry Iron O.

3.Turn Temperature Control Dial to OFF ( O ). Unplug iron and hold over a sink with soleplate facing down.

4.Turn Adjustable Steam Switch to MAX, while pressing Blast of Steam button often. Boiling water and steam will flow out of steam vents. Allow all water to drain from iron.

5.Gently move iron front to back to allow water to clean entire soleplate area.

6.If water still remains inside of soleplate, reheat iron as indicated in Step 2. Boiling water and steam could still flow out of steam vents.

5