Operating Instructions Safety Instructions
About the controls on the dehumidifier.
%
Controls
Tips Care and Cleaning
POWER Pad
Press to turn the dehumidifier on and off.
HUMIDITY CONTROL Pads
The humidity level can be set within a range of 35% RH (Relative Humidity) to 70% RH (Relative Humidity) in 5% increments.
For drier air, press the ▼ pad and set to a lower percent value (%).
For damper air, press the ▲ pad and set to a higher percent value (%).
When you first use the dehumidifier, set the humidity control to 45% or 50%. Allow at least 24 hours for the dehumidifier to achieve the humidity level. If you still have damper air than desired, set the humidity level to a lower setting.
FAN SPEED Pad
Controls the fan speed.
Press to set to HIGH or LOW fan speed.
Set the fan control to HIGH for maximum moisture removal. When the humidity has been reduced and quiet operation is preferred, set the fan control to LOW.
HUMIDITY LEVEL DISPLAY
Displays percent humidity level. Its accuracy is (+/– 5%).
BUCKET FULL LED
Indicates presence of bucket and its fill level.
Other Features
Consumer Support Troubleshooting
Glows when the bucket is ready to be emptied, or when the bucket is removed or not replaced in the proper position.
Auto Shut OffThe Water Level Control Switch shuts off the dehumidifier when the bucket is full, or when the bucket is removed or not replaced in the proper position. Also, when the bucket is out of position, the unit will beep 3 times.
Auto DefrostWhen frost builds up on the cooling coils, the compressor will cycle off until the frost disappears. The fan continues to run.
4
If a power outage occurred or if the unit was unplugged, the unit will display its prior setting. Note: If ON is in the display, the dehumidifier is operating continuously, but a specific humidity level is not set. You will need to reset the HUMIDITY CONTROL to the desired level.
Auto RestartOnce power is restored after a power outage, the unit automatically resumes operation after a 2 minute delay.