Window Installation Instructions
1 WINDOW REQUIREMENTS |
• These instructions are for a standard |
to modify them for other types of |
windows. |
CAUTION: If the sill support |
bolts do not contact the window sill, |
or if you have a window without a sill, |
you must order accessory kit RAK87 to |
properly install this air conditioner. Call |
800.626.2002 or visit ge.com. |
• All supporting parts must be secured |
to firm wood, masonry or metal. |
• The electrical outlet must be within |
reach of the power cord. |
• Follow the dimensions in the table and |
illustration for your model. |
2STORM WINDOW REQUIREMENTS
A storm window frame will not allow the air conditioner to tilt toward the outside, and will keep it from draining properly.
To adjust for this, attach a piece of wood to the sill.
WOOD PIECES –
WIDTH: 2″
LENGTH: Long enough to fit inside the window frame.
THICKNESS: To determine the thickness, place a piece of wood on the sill to make it 1/2″ higher than the top of the storm window frame or the vinyl frame.
Attach securely with nails or screws provided by the installer.
Models | A | B |
ASD06, ASM08, ASQ10, | 14 3/4″ min. | 24 |
ASV10 |
|
|
ASM10, ASQ12, ASV12 | 15 3/8″ min. | |
ASM12, ASQ14, ASV14 | 16 1/4″ min. | |
|
|
|
1/2″ higher than storm window frame
Storm window frame
1/2″ higher
than vinyl frame (on some windows)
Wood
Sill
Vinyl frame
A
B
(With accordion panels)
3REMOVE THE FRONT GRILLE (IF ATTACHED)
ARemove shipping tape, if present.
On models with a
lift it and remove the screw behind it (if present) that holds the grille in place.
On models with a
B Gently but firmly grasp
the lower grille corners, press in on the case sides and pull forward
to release.
NOTE: Do not pull the bottom edge toward you more than 3″ or
you may damage the tabs of the grille.
CLift the grille up and off the top tabs.
11