GE CVM2072SMSS dimensions GE Café 2.0 Cu. Ft. Over-the-Range Microwave Oven, Duct, Equivalent Feet

Models: CVM2072SMSS

1 3
Download 3 pages 61.07 Kb
Page 2
Image 2
Optional Accessories (Available at additional cost)

CVM2072SMSS

GE Café 2.0 Cu. Ft. Over-the-Range Microwave Oven

Optional Accessories (Available at additional cost)

Hood Exhaust Duct: Outside ventilation requires a HOOD EXHAUST DUCT. Read the following carefully.

Exhaust Connection: The hood exhaust has been designed to mate with a standard 3-1/4" x 1" rectangular duct. If a round duct is required, a rectangular-to-round transition adaptor must be used. Do not use less than a 6" diameter duct.

Rear Exhaust: If a rear or horizontal exhaust is to be used, care should be taken to align exhaust with space between studs, or wall should be prepared at the time it is constructed by leaving enough space between the wall studs to accommodate exhaust.

Maximum Duct Length: For satisfactory air movement, the total duct length of 3-1/4" x 10" rectangular or 6" diameter round duct should not exceed 140 equivalent feet.

ELBOWS, TRANSITIONS, WALL AND ROOF CAPS: etc., present additional resistance to airflow and are equivalent to a section of straight duct which is longer than their actual physical size. When calculating the total duct length, add the equivalent length of all transitions and adaptors plus the lengths of all straight duct sections. The chart below shows the approximate feet of equivalent length of some typical ducts.

Duct

Equivalent Feet

 

 

A. Rectangular-To-round

 

Transition Adaptor

5 ft.

 

 

B. Wall Cap

40 ft.

 

 

C. 90° Elbow

10 ft.

 

 

D. 45° Elbow

5 ft.

 

 

E. 90° Elbow

25 ft.

 

 

F. 45° Elbow

5 ft.

 

 

G. Roof Cap

24 ft.

Filler Panel Kits

JX40CT–Bisque

JX41–Black

JX40WH–White

When replacing a 36" or

42" range hood, this kit fills in the additional width to provide a custom built-in

appearance. For installation between cabinets only; not for

end-of-cabinet installation. Each kit contains two 3"-wide filler panels.

Two kits are needed for a 42" opening.

JX22SS – Stainless Steel

 

Decorative Panel Kit

3/8"

When replacing a Hi/Low

range with a microwave/

depth

convection oven or

 

Spacemaker over a range

 

model, this panel kit fills in

 

the area between the

 

microwave and range left

 

by the Hi/Low model.

 

Filter Kits

JX81H–Recirculating

Charcoal Filter Kit

To be used when the Spacemaker microwave oven cannot be vented to the outside.

30 19

Listed by

Underwriters

Laboratories

Specification Created 4/07

240261

Page 2
Image 2
GE CVM2072SMSS GE Café 2.0 Cu. Ft. Over-the-Range Microwave Oven, Duct, Equivalent Feet, JX22SS - Stainless Steel