Chapter 1: Setup and Connections
8Graphics contained within this publication are for representation only. Your unit might differ slightly.
Install Batteries in the Remote
1. Remove the battery compartment cover on the back of the remote.
2. Insert new batteries. Match the polarities (+ and –) on the batteries with the diagram inside the
battery compartment.
3. Put the battery compartment cover back on the remote.
Important Battery Information
• If you’re not going to use the remote for a month or more, be sure to remove the batteries because they can leak and cause damage.
• Dispose of batteries in the proper manner, according to federal, state, and local regulations.
• Any battery may leak electrolyte if mixed with a different battery type, if inserted incorrectly, if all batteries are not replaced at the same
time, if disposed of in fire, or if an attempt is made to charge a battery not intended to be recharged.
• Discard leaky batteries immediately. Leaking batteries can cause skin burns or other personal injury.
Point the Remote in the Right Direction and Put it in DVD Mode
When you want the remote to operate the DVD Player, point the remote at the DVD Player, notthe
TV. The remote has to be pointed in the correct direction and toward the correct component in
order for the remote control’s signal to communicate with the sensor on the component. Make sure
there is a clear path between the remote control and the component you want to operate, so the
signal isn’t blocked.
Make sure the remote is in DVD mode — press the DVD button.
Turn on the TV and DVD Player
1. Turn on your TV and tune it to the correct Video Input Channel (if you don’t know which
channel is your the Video Input channel, go to page 59 for help).
2. Press the ON•OFF button on the remote to turn on the DVD Player. If the player doesn’t turn on,
press the DVD button and then press ON•OFF.
IB/100N/GE/4_9 4/12/02 10:17 AM Page 8