Safety Instructions
About the washer features.
NOTE: Features may not be available on all washer models.
7 |
|
| Cycle Signal |
|
|
| Use the SIGNAL button to change the | Press the button until you reach the | |
|
|
| ||
|
|
| volume of the end of cycle signal. | desired volume. |
|
|
|
|
|
|
|
|
|
|
Instructions
8 | Prewash (on some models) |
|
Prewash is an extra wash before the main wash. Use it for heavily soiled clothes or for clothes with a care label that recommends prewashing before washing. Be sure to add
NOTE: When selecting prewash, it is recommended to use powder detergent in the main wash (detergent) compartment.
Operating
9 | Extra Rinse |
|
Use an extra rinse when additional rinsing is desired to remove excess dirt and detergent from soiled loads.
Installation Instructions
10 | Delay Start |
|
You can delay the start of a wash cycle for up to 18 hours on models GHDVH626, GCVH6260, WCVH6260, WBVH6240, WHDVH626, WCVH6600, WHDVH660, GCVH6600 and GHDVH670, and for up to 10 hours on models WBVH5100 and GBVH5140. Press the DELAY START button to choose the number of hours you want to delay the start of the cycle, then press the START button. The
machine will count down and start automatically at the correct time.
NOTE: If you forget to fully close the door, a reminder signal will beep reminding you to do so.
NOTE: If you open the door when the delay is counting down, the machine will enter the pause state. You must close the door and press START again in order to restart the countdown.
Troubleshooting Tips
11 | Lock |
|
You can lock the controls to prevent any selections from being made. Or you can lock the controls after you have started a cycle.
Children cannot accidentally start the washer by touching pads with this option selected.
To lock the washer, press and hold the lock button for 3 seconds. To unlock the washer controls, press and hold the lock button for 3 seconds.
The control lock icon on the display will light up when it is on.
NOTE: The POWER button can still be used when the machine is locked.
Consumer Support
12 |
| MY CYCLE (on some models) | |
| To save a favorite cycle, set the desired | ||
HOLD 3 SEC | MY CYCLE | ||
settings for wash cycle, soil level, spin speed | |||
TO STORE | |||
|
and wash temp settings and hold down the MY CYCLE button for 3 seconds. A beep will sound to indicate the cycle has been saved.
To use your custom cycle, press the
MY CYCLE button before washing a load.
To change the saved cycle, set the
8desired settings and hold down the MY CYCLE button for 3 seconds.
NOTE: When using MY CYCLE, wash options cannot be modified after the cycle has been started.
NOTE: If you change wash options with MY CYCLE before starting the cycle, the MY CYCLE light will turn off and you will be returned to the base cycle.
