GE GSD4610 Water standing in, the bottom of the tub, Water won’t pump, out of the tub, Problem

Problem	Possible Causes	What To Do
Water standing in	This is normal	• A small amount of clean
the bottom of the tub		water around the outlet on
		the tub bottom at the back
		of the tub keeps the water
		seal lubricated.
Water won’t pump	Drain is clogged	• If you have an air gap,
out of the tub		clean it.
		• Check to see if your kitchen
		sink is draining well. If not,
		you may need a plumber.
		• If the dishwasher drains into a
		disposer, run disposer clear.
Suds in the tub	Correct detergent	• Use only automatic dishwasher
	wasn’t used	detergents to avoid sudsing.
		Cascade® Automatic
		Dishwashing Detergent has
		been approved for use in all
		GE dishwashers.
		• To remove suds from the tub,
		open the dishwasher and let
		suds evaporate. Add 1 gallon
		of cold water to the tub. Close
		the door until it locks into
		place. Pump out water by
		pressing START/RESET, then
		immediately press START/RESET
		again. Repeat if necessary.
	Rinse agent	• Always wipe up rinse agent
	was spilled	spills immediately.
Stained tub interior	Detergent with	• Some detergents contain
	colorant was used	colorant (pigment or dyes)
		that will discolor the tub
		interior with extended use.
		Check the detergent cup
		for signs of any discoloration.
		If cup is discolored, change to
		detergent without any colorant.
		Cascade® Automatic
		Dishwashing Detergent has
		been approved for use in all
		GE dishwashers.
	Some tomato-based	• Use of the RINSE & HOLD cycle
	foods can stain	(on some models) after adding
		the dish to the load can
		decrease the level of staining. 21

Safety Information

Operating Instructions

Troubleshooting Tips

Customer Service