GE GSD4800 Before you call for service…, Safety Instructions Operating Instructions, Problem

Safety Instructions

Operating Instructions

Troubleshooting Tips

Consumer Support

Before you call for service…

Troubleshooting Tips

Save time and money! Review the charts on the following pages, or visit GEAppliances.com. You may not need to call for service.

Problem	Possible Causes	What To Do
Control panel lights go	Time too long between	• Each pad must be touched within 30 seconds of the others. To relight,
off when you’re setting	touching of selected	touch any pad again, or unlock and relatch the door.
controls	pads
Control panel responded	Door latch may not be	• Call for service.
to inputs, but dishwasher	properly seated
never filled with water
Dishwasher won’t run	Fuse is blown, or the	• Replace fuse or reset circuit breaker. Remove any other appliances
	circuit breaker tripped	from the circuit.
		• Try resetting the START/RESET pad.
Noise	Some of the sounds	• Soft food disposal shredding action.
	you’ll hear are normal	• Drain valve opening to pump water out.
		• Timer control as cycle progresses.
		• Detergent cup opening.
		• The motor stopping during the drying period.
		• Water draining out of the tub immediately after you touch the
		START/RESET pad.
	Utensils are not secure	• Make sure everything is secured in dishwasher.
	in the rack or something
	small has dropped into
	the rack
	Motor hums	• Dishwasher has not been used on a regular basis. If you do not use
		your dishwasher often, set it to fill and pump out once every week.
		This will help keep the seal moist and the garbage disposer clear.
Water standing in	This is normal	• A small amount of clean water around the outlet on the tub bottom
the bottom of the tub		at the back of the tub keeps the water seal lubricated.
Water won’t pump	Drain is clogged	• If you have an air gap, clean it.
out of the tub		• Check to see if your kitchen sink is draining well. If not, you may need
		a plumber.
		• If the dishwasher drains into a disposer, run disposer clear.
Suds in the tub	Correct detergent	• Use only automatic dishwasher detergents to avoid sudsing.
	wasn’t used	Cascade®, Cascade® Complete and Electrasol® Automatic Dishwashing
		Detergents have been approved for use in all GE dishwashers.
		• To remove suds from the tub, open the dishwasher and let suds
		evaporate. Add 1 gallon of cold water to the tub. Close and latch the
		dishwasher. Pump out water by pressing the START/RESET pad; then
		immediately press the START/RESET pad again. Repeat if necessary.
	Rinse agent	• Always wipe up rinse agent spills immediately.
	was spilled
Stained tub interior	Detergent with	• Some detergents contain colorant (pigment or dyes) that will discolor
	colorant was used	the tub interior with extended use. Check the detergent cup for signs
		of any discoloration. If cup is discolored, change to detergent without
		any colorant. Cascade®, Cascade® Complete and Electrasol® Automatic
		Dishwashing Detergents have been approved for use in all
		GE dishwashers.
	Some tomato-based	• Use of the RINSE ONLY cycle (on some models) after adding the dish
	foods can stain	to the load can decrease the level of staining.
Dishes don’t dry	Low inlet water	• Make sure inlet water temperature is correct.
	temperature	• Select HI TEMP RINSE and/or HEATED DRY.
12	Rinse agent dispenser	• Check the rinse agent dispenser.
	is empty