Safety Instructions
Operating Instructions
Troubleshooting Tips
Consumer Support
display
| Lights | What It | What |
|
|
|
|
|
|
|
| |
|
| If the sensing | come on during the first | the NORMAL or | |
|
| POTS & PANS cycles, |
| is not working | for service. The |
|
| dishwasher will continue |
| without the | . |
|
| NOTE: This light will NOT stay | entire cycle. |
| |
|
|
|
| ||
|
| Allow up to 90 seconds for the dishwasher | selecting | ||
|
| a new cycle. |
|
|
|
|
|
|
| ||
| Control Error | Press the START/RESET pad to turn off the beeper. Turn | the | ||
|
| breaker for 10 seconds, then restore power. If the | to | ||
| Control or Sequence | Press the START/RESET pad to turn off the beeper | will |
| Switch Error | attempt to reset. Then restart the wash cycle. If this |
|
| for service. |
|
Using the dishwasher.
Check the Water Temperature
The entering water must be at least 120°F and | hot water faucet nearest |
not more than 150°F for effective cleaning and to | the thermometer in a |
prevent dish damage. Check the water temperature | continuously into the |
with a candy or meat thermometer. Turn on the | stops rising. |
Use Jet-Dry ® Rinse Agent
Filling the Dispenser
Fill the rinse agent dispenser until it reaches the bottom of lip inside the opening. Replace cap.
To check if rinse agent is needed, press the clear center of the fill cap 2 or 3 times. If rinse agent fills the center of the cap, you have enough.
A full dispenser should last about one month.
If rinse agent spills, wipe up the excess.
6