27
GEAppliances.com
Oven Heating Elements
Do not clean the bake element or the broil
element. Any soil will burn off when the elements
are heated.
To clean the oven floor, gently lift the
bake element. Clean with warm soapy
water.
Oven Racks
Clean the oven racks with an abrasive
cleanser or scouring pad. After cleaning,
rinse the shelves with clean water and dry
with a clean cloth.
If your oven is equipped with gray
porcelain-coated oven racks, they may
be cleaned in the oven during the self-
clean cycle.
NOTE:
■If your oven is equipped with shiny, silver-
colored oven racks, remove them before you
begin the self-clean cycle.
■If your oven is equipped with gray porcelain-
coated oven racks, they may be left in the oven
during the self-clean cycle.
To make the racks slide more easily, apply
a small amount of vegetable oil to a paper
towel and wipe the edges of the oven
racks with the paper towel. Do not spray
with Pam®or other lubricant sprays.
Broiler Pan and Grid
Do not clean the broiler pan or grid in a
self-cleaning oven.
After broiling, remove the broiler pan
from the oven. Remove the grid from the
pan. Carefully pour out the grease from
the pan into a proper container.
Wash and rinse the broiler pan and grid
in hot water with a soap-filled or plastic
scouring pad.
If food has burned on, sprinkle the grid
with detergent while hot and cover with
wet paper towels or a dishcloth. Soaking
the pan will remove burned-on foods.
Both the broiler pan and grid may be
cleaned with a commercial oven cleaner.
Both the broiler pan and grid can also
be cleaned in a dishwasher.
After broiling, remove the broiler pan
from the oven. Do not store a soiled
broiler pan and grid anywhere in
the range.
Oven Light Replacement
CAUTION: Before replacing your oven light
bulb, disconnect the electrical power to
the range at the main fuse or circuit breaker
panel.
Be sure to let the light cover and bulb
cool completely.
To remove the cover:
Hold a hand under the cover so it
doesn’t fall when released. With
fingers of the same hand, firmly
push back the wire cover holder.
Lift off the cover.
Do not remove any screws to remove the cover.
Replace bulb with a 40-watt
appliance bulb.
To replace the cover:
Place it into groove of the light
receptacle. Pull wire forward to the
center of the cover until it snaps
into place.
Connect electrical power to the
range.
Wire cover holder.
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support