41
Safety Instructions Operating InstructionsSafety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support
www.GEAppliances.com
Problem Possible Causes What To Do
Control signals after You forgot to enter a •Touch the BAKEpad and desired temperature or
entering cooking time bake temperature or the SELF CLEAN LO/STD pad and desired clean time.
or start time cleaning time.
Display goes blank A fuse in your home may •Replace the fuse or reset the circuit breaker.
be blown or the circuit
breaker tripped.
The clock is in the •See the Special features of your oven control section.
black-out mode.
Display flashes Power failure. •Reset the clock.
Unable to get the Oven control pads were •The BROIL HI/LO and BAKE pads must be touched at
display to show “SF” not touched properly. the same time and held for 3 seconds.
“Probe” appears in This is reminding you to •Enter a probe temperature.
the display enter a probe temperature
(on some models) after plugging in the probe.
Power outage, Power outage or surge. •Reset the clock. If the oven was in use, you must reset
clock flashes it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
Steam from the vent When using the convection •This is normal.
feature (on some models),
it is normal to see steam
coming out of the oven
vent. As the number of racks
or amount of food being
cooked increases, the amount
of visible steam will increase.
“Burning” or “oily” This is normal in a new oven •To speed the process, set a self-clean cycle for a
odor emitting from and will disappear in time. minimum of 3 hours. See the Using the self-cleaning
the vent oven section.
Strong odor An odor from the insulation •This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise A cooling fan or a convection •This is normal. The cooling fan will turn off and on
fan (depending on the to cool internal parts. It may run after the oven is
function you are using) may turned OFF. The convection fan (on some models)
automatically turn on and off. will cycle on and off until the function is over or the
door is opened.