11
REMOVE EXHAUST ADAPTORRemove the 7″round exhaust adaptor from the top of
the hood. Set it aside along with its mounting screws.
7″round
exhaust
adaptor
REMOVE FILTERSRemove the shipping tape holding the metal grease
filters in place. Pull down on the filter tabs and lift
the filters out. Set them aside.
REMOVE BOTTOM COVEROn models so equipped, remove the bottom cover
from the hood. Set the cover and its mounting
screws aside.
Bottom cover
(held in place
with 2
screws)
REMOVE OTHER EXHAUST ADAPTORRemove the 31⁄4″x 10″rectangular exhaust adaptor
from inside the hood. Set it aside along with its
mounting screws and parts bag. Depending on the
model, the exhaust adaptor will be located on the
left or right side.
31⁄4″x 10″
rectangular
exhaust adaptor
31⁄4″x 10″
rectangular
exhaust adaptor
REMOVE WIRING COVEROn models so equipped, remove the wiring cover
from inside the hood. Set the cover and its mounting
screw aside.
Wiring
cover
REMOVE WIRING KNOCKOUTRemove either the top or the back wiring knockout as
needed and install an approved strain relief clamp.
Strain relief
clamp
2
3
4
5
6
7
Filters
Installation Instructions