GE JSP46SPSS dimensions GE 30 Slide-InCleanDesign Electric Range, KW Rating, 240V, 12.4, 208V

JSP46SP

GE® 30" Slide-In CleanDesign Electric Range

Dimensions and Installation Information (in inches)

			Shave Raised Edge To Clear
	30"	Min.	31-1/8" Wide Control Panel
Recommended			Excluding Models JSS28 and JSP39
6" Min.
From Walls			9/16

KW Rating

240V	12.4
208V	9.3

Note: Cabinets installed adjacent to slide-in ranges must have an adhesion spec of at least 194° temperature rating.

Note: To reduce the possibility of scorching the side walls above the countertop when no load is present on burners, it is recommended that a minimum 6" spacing from adjacent side wall be allowed for possible extended high-heat element operation.

	30" Min.
23-3/16	Acceptable
	Electrical	13" Max.
	Outlet Area	15" Min.
		25

Receptacle Locations: For all 30" Slide-In Ranges locally approved flexible service cord or conduit must be used because terminals are not accessible after range installation. See shaded area

in drawing for location of electrical outlet box. Recommended outlet locations allow range to be installed directly against rear wall.

35-7/8"–38"
from floor to
countertop	2-1/2
	7-1/2

Optional Kits For Slide-In

Electric Ranges

(Available At Additional Cost)

Accessory Backguards (Attaches to the back of range as a backguard when unit is installed in 30" free-standing

Body Sides

(Slide-in ranges are sold without sides installed. Can be installed on either left or right when unit has one exposed side [no cabinet adjacent]. Kit contains

Optional Lower Trim Kits (If counter height is greater than 36.5", a lower trim kit is recommended to extend the useful height to 38" maximum)

JXS56BB – Black

2-1/2

30

Accessory

Backguard

cutout)

JXS32SS (Stainless) - 4" High

1 body side) JXS77BB (Black)

24

2-7/8"

31-1/4 30 A/B*

JXS32BB (Black) - 4" High JXS37BB (Black) - 5-1/4" High

Rear Filler Strip

WB07T10680 - Black Filler Strip Assembly

To Front

Surface Of

Countertop

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service,

If you are NOT using the optional Filler or Backguard:

23-3/16

30

If you are using the optional

20-5/8" Door

Clearance

From Front

Surface of

Countertop

36-1/4

25-3/4**	*JXS37 is 5-1/4" and JXS32 is 4"
(excluding handle)	**Total depth from wall to

front of closed oven door including handle is 27-13/16.

800.626.2000.

Filler or Backguard:

Dimension and installation information are shown in inches.

25

30

All GE ranges are equipped with	Listed by
an Anti-Tip device. The installation	Underwriters
of this device is an important,
required step in the installation	Laboratories
of the range.

Specification Revised 7/09

320650