CLOCK AND TIMER
(on some models)
You have the choice of having the timer show the time counting down or the time of day. In either case, the timer will signal at the end of the timer period to alert you that the time is up.
(appearance may vary)
To Set the Clock
NOTE: When you first plug in the range or after a power failure, the entire Clock/Timer display will light up.
1.Press the CLOCK pad.
2.Press and hold the + or – pad and the time of day will change 10 minutes at a time. To change the time by single minutes, give the pads short taps.
3.Press the CLOCK pad to start the clock.
To Set the Timer
1.Press the TIMER ON/OFF pad.
2.Use the + and – pads to set the timer. Short taps on the + or – pad change the timer’s setting one minute at a time. Pressing and continuing to hold the + pad increases the setting ten minutes at a time.
3.Once you have set your timer, press the TIMER ON/OFF pad to start timing.
As the timer counts down, a signal will indicate when one minute is left. After this signal, the display will count down in seconds. When time runs out, a final signal will sound. Press the TIMER ON/OFF pad to stop the signal.
To Change or Cancel the Timer Setting
When the timer is counting down, use the + and – pad to change the remaining time, or press the TIMER ON/OFF pad to stop the timer. The timer cannot be cancelled unless you have fully completed “set timer” instructions above.
Display Clock While Timer Is Operating
Pressing the CLOCK pad while the timer is operating will not interfere with the timer’s operation; the display will change to show the clock, but the timer will continue to count down and will still signal when time is up. Press the TIMER ON/OFF pad again to change the display back to show the timer.
10
