50
Troubleshooting Tips
Before you call for service…Operating
Instructions Safety InstructionsCare and Cleaning
Installation
Instructions
Troubleshooting
Tips
Consumer Support
Problem Possible Causes What To Do
Oven light does Light bulb is loose or defective. • Tighten or replace the bulb.
not work Plug on range is not completely • Make sure electrical plug is plugged into a live, properly
inserted in the electrical outlet. grounded outlet .
Oven will not The oven temperature is too • Allow the range to cool to room temperature and
self-clean high to set a self-clean operation. reset the controls.
Oven controls improperly set. • See the Using the self-cleaning oven section.
“Crackling” or This is the sound of the • This is normal.
“popping” sound metal heating and cooling
during both the cooking and
cleaning functions.
Excessive smoking Excessive soil. • Touch the Clear/Off pad. Open the windows to
rid the room of smoke. Wait until the LOCKED DOOR
light goes off. Wipe up the excess soil and reset the
clean cycle.
Oven door will not open Oven too hot. • Allow the oven to cool below locking temperature.
after a clean cycle
Oven not clean after a Oven controls not properly set . • See the Using the self -cleaning oven section.
clean cycle Oven was heavily soiled. • Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
“LOCK DOOR” flashes The self-clean cycle has been • Close the oven door.
in the display select ed but the door is not
closed.
LOCKED DOOR light The oven door is locked • Touch the Clear/Off pad. Allow the oven to cool.
is on when you want because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
“F—and a number or You have a function error code. • Touch the Clear/Off pad. Allow the oven to cool for
letter” flash in the display one hour. Put the oven back into operation.
If the function code repeats. • Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
Oven shelves are The shelves were cleaned in a • Apply a small amount of vegetable oil to a paper
difficult to slide self-clean cycle. towel and wipe the edges of the oven shelves with
the paper towel. Do not spray with Pam®or other
lubricant sprays.