Specification Created 7/03
250202
TM
PDW9700JII – GE Profile™Fully Integrated Built-In Dishwasher

Built-In Dishwasher Dimensions (in inches)

Electrical Rating
Voltage AC. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 120
Hertz. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60
Total connected load amperage. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9.1
Calrod®heater watts max. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 875
For use on adequately wired 120-volt, 15-amp circuit having 2-wire service
with a separate ground wire. This appliance must be grounded for
safe operation. For answers to your Monogram,
® GE Profile™or
GE®appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
As an ENERGY STAR®partner,
GE has determined that this product
meets the ENERGY STAR®
guidelines for energy efficiency.
Dishwasher Rough-In Information
Note: Dishwasher must not be installed more than ten feet
from sink for proper drainage. All plumbing and electrical
work must be in accordance with local codes.
Note: If a flush look is needed, a 25" base cabinet needs
to be used (except Profile and Triton XL models).
The power cord and connections must comply with the
National Electrical Code Section 422 and/or local codes
and ordinances. The cord must be no longer than six feet
from the junction box to the receptacle.
This wall area
must be free of
pipes or wires
Countertop
4
6
Hot
water
line on
left
44
2Plumbing and electrical
service must enter
inside shaded area
24" From wall
24" MIN.
90°
19" MIN. from wall
24"
MIN.
6
34" to 34-3/4"
Underside
of countertop
to floor
55
90°
Electrical
wiring on
right
Electrical
wiring is
3" from
cabinet

Custom Panel for Model PDW9700JII

Dishwasher comes panel-ready.

Installation Information (in inches)

B
A
Custom
Panel Size
Floor
Cabinets
Side
View
Countertop
3/4" Max.
Bottom of
Adjacent Cabinetry
The most common panel dimensions are 30-1/4"H
and 23-3/4"W.
STEP A: Determine custom panel height
1. Measure Dimension A from underside of
countertop to bottom of adjacent cabinets.
2. Subtract 1/4". This allows a 1/4" clearance gap
between the underside of the countertop and
the top of the dishwasher door.
Height is equal to A minus 1/4"
STEP B: Determine custom panel width
1. Measure dimension B, the rough opening width.
2. Subtract 1/4" for clearance (1/8" on each side).
Width is equal to B minus 1/4"
Note: 23-1/8" min. panel width and 26-1/4" min.
panel height is required to cover the door frame.
Panel height varies depending on installation.
Consideration must be given to door swing
clearance above the toekick.