GE PDW8100 Series, PDW8200 Series, PDW8500 Series, PDW8600 Series, PDW8700 Series, PDW8800 Series, PDW9200 Series, PDW9700 Series, PDW9800 Series IMPORTANT

Installation Instructions

• Do not over tighten 90° elbow, water valve bracket

could bend or water valve fitting could break.

• Position the end of the elbow to face the rear of the

dishwasher.

STEP 5 INSTALL 90° ELBOW

• Wrap 90° elbow with thread seal tape.

• Install a 90° elbow onto the water valve.

Figure M

Figure K

STEP 3 REMOVE TOEKICK

• Remove the two toekick screws.

• Screw leveling legs back into the dishwasher

frame, approximately 1/4" from frame as shown.

Figure J

STEP 2 REMOVE WOOD BASE,

INSTALL LEVELING LEGS

IMPORTANT – Do not kick off

wood base! Damage will occur.

• Move the dishwasher close to the installation

location and lay it on its back.

• Remove the four leveling legs on the underside of

the wood base with an adjustable

wrench or 15/16" socket.

• Discard base.

Contents

Main PARTS SUPPLIED: MATERIALS YOU WILL NEED : Materials For New Installations Only: TOOLS YOU WILL NEED: For New Installations Only: PREPARE DISHWASHER ENCLOSURE DRAIN REQUIREMENTS DETERMINE DRAIN METHOD CABINET PREPARATION Clearance for Door Opening 2" Minimum PREPARE ELECTRICAL WIRING STEP 1 CHECK DOOR BALANCE PDW8100-PDW8800 Series PREPARE HOT WATER LINE Water Line Connection CAUTION: BEFORE YOU BEGIN STEP 5 INSTALL 90 ELBOW STEP 3 REMOVE TOEKICK STEP 2 REMOVE WOOD BASE, INSTALL LEVELING LEGS IMPORTANT Power Cord (If Used) Water Line House Wiring Drain Hose Insulation Blanket STEP 9 INSTALL TRIM PIECES STEP 8 SLIDE DISHWASHER PARTIALLY INTO CABINET STEP 7 INSTALL DRAIN HOSE, GUIDE THROUGH CABINET STEP 6 POSITION WATER LINE AND HOUSE WIRING IMPORTANT Page STEP 13 CONNECT WATER SUPPLY IMPORTANT STEP 14 CONNECT DRAIN LINE DRAIN LINE INSTALLATION IMPORTANT Cutting Lines IMPORTANT: Do not cut corrugated portion of hose STEP 16 PRE-TEST CHECK LIST STEP 19 LITERATURE STEP 17 STEP 18 REPLACE TOEKICK DISHWASHER WET TEST Specification Created 7/03 PDW9700JII GE ProfileFully Integrated Built-In Dishwasher 24 for custom handle 27-1/2 4 (Adjustable) 3/4" Thick Custom Panel Template Instructions For PDW9700J Series STEP 2 DRAW CENTERLINE STEP 4 INSTALL MOUNTING SCREWS AND SPACERS STEP 5 INSTALL CUSTOM HANDLE 25-9/16"

GE installation instructions IMPORTANT

Models: PDW8100 Series PDW8200 Series PDW8500 Series PDW8600 Series PDW8700 Series PDW8800 Series PDW9200 Series PDW9700 Series PDW9800 Series

STEP 5 INSTALL 90° ELBOW

STEP 3 REMOVE TOEKICK

STEP 2 REMOVE WOOD BASE,

INSTALL LEVELING LEGS