GE PP912KMCC dimensions PP912TM/KM/BM, GE Profile 30 Built-In CleanDesign Electric Cooktop

PP912TM/KM/BM

GE Profile™ 30" Built-In CleanDesign Electric Cooktop

Dimensions and Installation Information (in inches)

KW Rating

240V	7.6
208V	5.7
Breaker Size
240V	40 Amps†

†Note: Check local codes for required breaker size

Important: Requires a 5" free area between the bottom of the cooktop to any combustible material, i.e., shelving. Free area not required when installing wall oven underneath cooktop. Refer to installation instructions. Requires a 15" minimum from cooktop to adjacent overhead cabinets. Units are furnished with a

29-3/4 21-3/8

Cooktop3-1/4*

19-5/8

13" MAX. depth

30" MIN. to unprotected cabinet

208V 30 Amps†

48" flexible armored cable.

28-1/2

1-3/4" to

15" MIN. to cabinet

1-1/2" MIN. clearance to side wall

Note: 30" Ribbon cooktops are approved for use over select GE 27" and GE 30" Single Wall Ovens and Warming Drawers. Refer to cooktop and wall oven/ warming drawer installation instructions packed with product for current dimensional data. If installed with a GE Profile™ Telescopic Downdraft System, consult both the cooktop and downdraft installation instructions packed with product before installing. Cooktop gas/electric supply may need to be re-routed to install downdraft. Consult cabinet and countertop manufacturer’s specs for flush mount installation prior to install. Before installing, consult installation instructions packed with product for current dimensional data.

Filler Trim Kit: When replacing an old GE 30" cooktop (with larger opening) use the following one-piece trim kit to fill in the over-size hole. Available at additional cost. JXTR32W (True White) JXTR32B (Black glass) JXTR32C (True Bisque)

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

2-1/2** Required

*Depth of unit at conduit connection location (rear) is 6-1/2" on models PP980/975/950/945 and 4-5/8" on models PHP900/PP972/962/942/932/912, JP655/356/346.

**Raised bull nose countertops may require up to 3/8" additional clearance to prevent interference with curved front.

rear wall

1-1/2" MIN. clearance to side wall from cut-out

Electrical junction box 16" MIN. below countertop

from cut-out

Cut should not interfere with cabinet structure at front

Listed by

Underwriters

Laboratories

Specification Revised 12/07 220581