GE installation instructions PP950WM/BM, GE Profile 30 Built-In CleanDesign Electric Cooktop

PP950WM/BM

GE Profile™ 30" Built-In CleanDesign Electric Cooktop

KW Rating

240V	7.4
208V	5.6
Breaker Size
	†

†Note: Check local codes for required breaker size

Important: Requires a 5” free area between the bottom of the cooktop to any combustible material, i.e., shelving. Free area not required when installing wall oven underneath cooktop. Refer to installation instructions. Requires a

29-3/4 21-3/8

Cooktop3-1/4*

19-5/8

13" MAX. depth

30" MIN. to unprotected cabinet

240V	40 Amps
208V	30 Amps†

15” minimum from cooktop to adjacent overhead cabinets. Units are furnished with a 48” flexible armored cable.

28-1/2

1-3/4" to rear wall

15" MIN. to cabinet

1-1/2" MIN. clearance to side wall from cut-out

Note: 30” Ribbon cooktops are approved for use over select GE 30” Single Wall Ovens and Warming Drawers. All 30" ribbon cooktops can be installed over 27" wall ovens and warming drawers. Refer to cooktop and wall oven/ warming drawer installation instructions packed with product for current dimensional data. If installed with a GE Profile™ Telescopic Downdraft System, consult both the cooktop and downdraft installation instructions packed with product before installing. Cooktop gas/electric supply may need to be re-routed to install downdraft. The countertop must be at least 26" deep with a flat surface area of 23-1/2" or more, front to back. In addition, other clearances to the front edge of the countertop must be considered. Consult cabinet and countertop manufacturer’s specs for flush mount installation prior to install. Before installing, consult installation instructions packed with product for current dimensional data.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

2-1/2** Required

*Depth of unit at conduit connection location (rear) is 6-1/2" on models PP980/975/950/945 and 4-5/8" on models PHP900/PP972/962/942/932/912, JP655/356/346.

**Raised bull nose countertops may require up to 3/8" additional clearance to prevent interference with curved front.

1-1/2" MIN. clearance to side wall from cut-out

Electrical junction box 16" MIN. below countertop

Cut should not interfere with cabinet structure at front

Listed by Underwriters Laboratories

Specification Revised 12/07 220597