TM
PSW26SGR – GE Profile Arctica® ENERGY STAR® 25.5 Cu. Ft.
1.
Hinge Screws
4.
3.
2.
Toekick Screw
Wire Harness Water Line Coupler
Specification Revised 7/04
To Remove Top Cap and Doors on PSW26SGR
Step 1: Locate and remove two Phillips head screws on the top of the refrigerator. Remove two screws, one on each side at the rear of the top cap. Lift off and remove top cap.
Step 2: Open both doors. Remove one screw on each side of the toekick. Pull forward to remove toekick.
Step 3: On the freezer door, disconnect water line coupler by pushing against the collar on the left side. Disconnect wire harness.
Step 4: Use a Torx
are removed.
Step 5: Place refrigerator onto a hand truck, upright and against one side. Move refrigerator to the installation location.
Reinstall Doors, Top Cap
Step 6: Carefully lower doors onto bottom hinges. Be sure to route the tubing and electrical connector through the bottom hinge. Reinstall top hinges.
Step 7: Place cap over the top of the refrigerator. Reinstall the original screws in the top and back of the cap.
Step 8: Reconnect the wiring harness and waterline.
| Total volume and shelf |
| As an ENERGY STAR® |
|
| area are calculated by |
| partner, GE has determined |
|
| the Association of Home | that this product meets the | R | |
| Appliance Manufacturers’ | ENERGY STAR guidelines |
| |
| standards. |
| for energy efficiency. |
|
|
| For answers to your Monogram,® GE Profile™ or |
| |
| Listed by | GE® appliance questions, visit our website at |
| |
R | Underwriters | GEAppliances.com or call |
| |
Laboratories |
| |||
| GE Answer Center® service, 800.626.2000. |
| ||
|
|
|
210398