Care and Cleaning
Advantium Oven
1. To replace the cooktop light/
night light, first disconnect the
power at the main fuse or circuit
breaker panel.
2. Remove the screws from the
side of the light compartment
cover and lower the cover until
it stops.
3. Be sure the bulb(s) to be replaced
are cool before removing. Break
the adhesive seal by gently
unscrewing the bulb(s).
Replace with 40-watt (max.) incandescent
bulbs. Order WB02X4253 from your GE
supplier. High-intensity 40-watt bulbs
(40S11N/1), available in supermarkets
and hardware stores, may also be used for
replacements.
4. Raise the light cover and replace
the screws. Connect electrical
power to the oven.
Remove screws
Cooktop light/night light
The metal filters trap grease released
by foods on the cooktop. They also
prevent flames from foods on the
cooktop from damaging the inside
of the oven.
For this reason, the filters must
always be in place when the hood
is used. The vent filters should be
cleaned once a month, or as needed.
To remove, slide them to the side
using the tabs. Pull down and out.
To clean the vent filters, soak them
and then swish around in hot water
and detergent. Don’t use ammonia
or ammonia products because
they will darken the metal. Light
brushing can be used to remove
embedded dirt.
Rinse, shake and let dry before
replacing.
To replace, slide the filters into
the frame slots on the side of each
opening. Press up and to the side
to lock into place.
Reusable ventfiltersRemoving andcleaning thefilters
39