GE ZBD4200DWW dimensions ZBD4500DSS - GE Monogram Built-InDishwasher, Optional Kits

Monogram.™

ZBD4500DSS - GE Monogram Built-In Dishwasher

Dimensions and Specifications (in inches)

24"

4"

24 3/4"

4 1/2"

34" Min.

35" Max.

25"

(Including 1/4"

Rear Insulation)

Design Information: Designed for versatility, these dishwashers adapt to virtually any installation. This dishwasher is supplied as a stainless steel model.

To achieve a custom flush appearance, standard 24" base cabinets should be moved forward by use of spacer blocks.

Optional Kits:

•GPF53 Mounting Kit-Special brackets for installing dishwasher beneath countertops of stone or other materials which will not accept screws.

Additional Specifications: A 120 Volt, 60 Hz power supply is required when using a power cord, an individual properly grounded branch circuit protected by a 15 or 20 amp circuit breaker or time delay fuse is recommended. Install a 3-prong electrical receptacle at least 6" above the floor and within 18" of the right or left adjacent cabinet wall. Otherwise wiring must enter the cutout in shaded area shown. A double, side-by-side installation requires two separate circuits.

The hot water line must enter the cutout in the shaded area from the right, left, rear or through the floor. The water line should be 3/8" O.D. copper or 1/2" O.D. plastic. Installation of an easily accessible hand shut-off valve is strongly recommended.

The dishwasher should be placed no more than 10 feet from the sink for proper drainage.

For a corner installation, allow 2” clearance between dishwasher and adjacent cabinet or wall.

Toekick

3 1/4"

	This Wall Area
	must be Free of
34-1/2"±1/4"	Pipes or wires			24"
				Min.
Underside of	5"	4"	5"
				4"
Countertop
to Floor	Plumbing and Electric Services				Cabinets
	Must Enter Inside This Area
				6"	Square
					and Plumb
		24"
		Min.

For answers to your Monogram,® GE Profile Performance Series,™

GE Profile™ or GE appliance questions, call GE Answer Center® service, 800.626.2000.

Listed by

Underwriters

RLaboratories

Specification Revised 10/99