GE ZCGS150LSS dimensions ZCGS150RSS - GE Monogram Stainless Steel 15 Built-In Compactor, 34 to

ZCGS150RSS - GE Monogram Stainless Steel 15" Built-In Compactor

Dimensions and Installation Information (in inches)

This compactor is designed as a built-in appliance only. It may be located in any convenient space under a countertop.

DO NOT OPERATE FREE-STANDING because the compactor will tip over when the drawer is pulled out.

Additional Specifications: A 115 Volt, 60 Hz. power supply is required. An individual properly grounded branch circuit protected by a 15- or 20-amp circuit breaker or time delay fuse is recommended. Install a properly grounded 3-prong

Front View (not to scale)

15"

34" to 35"

min.

oor.

om e

electrical receptacle recessed into the back wall. Electrical outlet location is critical for proper cord storage when compactor is installed.

If the compactor is to be located in or near a corner of base cabinets, allow 6” minimum clearance from the corner for bag removal from the right side.

33-3/4" min. to 35" max.

14-7/8" Stainless steel model

24" case/door depth 26" including handle

24" min. min.

Locate the outlet 18" min. from the floor.

3" min. from either side

Clearances: Allow 6" clearance to a vertical wall on the right side for bag removal. Allow 23" at the front for a full drawer opening.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at geappliances.com or call GE Answer Center® service, 800.626.2000.

Listed by

Underwriters

Laboratories

Specification Created 4/09 160011