GE ZDWI240WII dimensions Dimensions and Specifications in inches Installation Space

ZDWI240WII – GE Monogram® Wine Reserve

Dimensions and Specifications (in inches) Installation Space

		Locate Outlet
	10-1/2"
			24" Min.
	9"
34-1/2"-35"		Max.
				24-1/8" Framed m
	1-1/2"
				23-3/4" Stainless
		23-3/4" Min.
				models

34-1/4"-

34-3/4"

25-1/2"
Including	23-3/4"
Handle

The cutout depth must be 24"

The cutout dimensions shown allow for a full door swing and access to the pull-out racks when installed as a built-in.

• The wine reserve can be free-standing.

Note: If installing between frameless cabinets, a 1/2" wide filler strip or side panel may be required. The filler strip will act as a spacer between the door case and adjacent cabinet and will prevent interference with cabinet door swing. The width of the opening must include filler panels.

•Wine reserve is vented at the front toekick to allow built-in undercounter installation.

•Door swing is reversible.

Additional Specifications:

•A 120 volt 60Hz., 15 or 20 amp power supply is required. An individual property grounded branch circuit or circuit breaker is recommended. Install a properly grounded 3-prong electrical receptacle recessed into the back wall as shown. Electrical must be located on rear wall as shown. Note: GFI (ground fault interrupter) is not recommended.

Specification Created 10/07

Product Clearances

24"

Cabinet

Wall

110˚

14" Minimum

All models are factory set for a 110° door swing.

For a minimum 90° door swing:

• Allow 4" min. clearance to wall on the hinge side.

For a full 110° door swing:

• Allow 14" min. clearance to wall on the hinge side.

Listed by

Underwriters

Laboratories

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at GEAppliances.com or call GE Answer Center® service, 800.626.2000.

120037