GE ZGU366NPSS Natural Gas ZGU366LPSS Liquid Propane, Backsplash Accessories, Gas Supply

ZGU366NPSS (Natural Gas)

ZGU366LPSS (Liquid Propane)

GE Monogram® 36" Professional Gas Rangetop with 6 Burners

Dimensions and Installation Information

Backsplash Accessories

The rangetop requires a 12" minimum clearance to a vertical combustible surface at the rear. A backsplash is required for installations with less than 12" clearance. The following backsplash accessories are available, or a custom, non-combustible backsplash can be used.

ZX12B36PSS, 12" backsplash

ZXADJB36PSS, 30"-36" adjustable-height backsplash with warming shelf

Backsplash with Warming Shelf

All Monogram® Professional Hoods feature infrared warming lights. The 30"-36" adjustable backsplash with warming shelf is a perfect complement when installed with the tapered or straight-sided hoods.

•Restaurant-Style Professional Hoods are shipped with a 22" stainless steel backsplash and warming shelf.

Side View with a Backsplash

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

Advance Planning for 36"

Professional Rangetops

Professional rangetops offer a number of choices in size and rangetop configurations.

•All Professional rangetops are factory set for natural or liquid propane gas. The correct model should be ordered for the installation situation.

Note: Conversion kits are included with the rangetop if the wrong gas type was ordered. High Altitude kit, WB28K10553, is also available. The kits must be installed by a qualified service technician at additional cost.

Electrical Requirements

Rangetops must be supplied with 120V, 60Hz, and connected to an individual, properly grounded branch circuit protected by a 15 amp circuit breaker or time-delay fuse.

Gas Supply

•Natural gas models are designed to operate at 5" water column pressure. For proper operation, the pressure of the natural gas supplied to the regulator must be between 7” and 13” water column.

•The liquid propane models are designed to operate at 10" water column pressure. For proper operation, the pressure of the LP source to the regulator must be between 11” and 13” water column.

Specification Created 7/08 130456