Alternate Bracket
Screw Holes
“L” Bracket
8

INSTALL COOKTOP

• Lower the cooktop into the opening. Make sure the
cooktop is evenly seated and supported. A side frame
gasket will seal the cooktop to the countertop.
• “L” brackets with screws are provided to secure the
cooktop to the countertop or to adjacent cabinetry.
– Alternate screw hole locations on the sides of the
cooktop allow for varying thicknesses of countertops
or side cleats.
• Select the bracket location; secure the bracket to the
cooktop with 2 screws.
• Drive one screw through the bottom of the “L” bracket
and into countertop or side cleats.

STEP 3

CONNECT COOKTOP TO GAS

A manual shut-off valve must be installed where
it will be accessible.

Assure that gas is turned off at the shut-off valve.

• Install the supplied pressure regulator onto the end
of the gas inlet.
• You can install a 90°elbow (not supplied) onto the
gas inlet and route the gas connections to avoid
interference with drawers or other cabinetry features.
• Make sure the regulator is installed in the right
direction. See arrow on the underside of the regulator.
NOTE: Instead of using solid piping to connect to
pressure regulator, an approved flexible metal appliance
connector may be used between the pipe stub and the
shut-off valve to the pressure regulator, if local codes
permit.
• Appropriate flare nuts and adapters are required at
each end of the flexible connector.
WARNING:Do not use a flame to
check for gas leaks.
AVERTISSEMENT :
Il ne faut pas utiliser de flamme pour vérifier
s’il y a des fuites.
IMPORTANT: Disconnect the cooktop and the individual
shut-off valve from the gas supply piping system during
any pressure testing of that system at test pressures
greater than 1/2 psig. Isolate the cooktop from the gas
supply piping system by closing the individual manual
shut-off valve to the cooktop during any pressure testing
of the gas supply piping system at test pressures equal
to or less than 1/2 psig.
• Turn on gas and check for leaks:
–Use a liquid leak detector at all joints and connections
in the system.

STEP 4

Regulator
(Supplied)
Solid Piping
or Flexible
Connector
Shut-Off
Valve
Pipe Stub From
House Gas Supply
Cooktop Burner Box
Gas Inlet
Installation
Note: Pipe stub extends
about 1" below burner box.