Grease filters
Painted or stainless steel surfaces
Save time and money!
Review the troubleshooting tips on this page first and you may not need to call for service.
Care and Cleaning
Downdraft Vent System
The efficiency of your downdraft depends on a clean filter. Frequency of cleaning depends on the type of cooking you do. Grease filters should be cleaned at least once a month. Never operate the downdraft without the filters in place.
To remove: Pull the filters out by grasping them and pulling straight up.
To clean: Soak and then agitate in a hot detergent solution. Light brushing may be used to remove embedded soil. Rinse, shake and remove moisture before replacing.
With careful handling, the filter will last for years. If replacement becomes necessary, order the part from your dealer.
Do not use a
To clean the stainless steel surface, use warm sudsy water, a stainless steel cleaner such as Kleen King®, or an
After cleaning, use a stainless steel polish, such as Stainless Steel Magic®, Revere Copper and Stainless Steel Cleaner®, or Wenol All Purpose Metal Polish®. Follow the product instructions for cleaning the stainless steel surface.
| Before You Call For Service… | |
|
|
|
|
| Downdraft Vent System |
PROBLEM | POSSIBLE CAUSE | |
|
| |
FAN DOES | • The vent is not fully extended. Press the raise/lower pad. | |
NOT WORK | • The blower control switch may be in the OFF position. | |
| ||
| Slide it to the right. | |
|
| |
VENT DOES | • The vent is not plugged into an outlet. Plug the vent into a 120V | |
NOT WORK | power outlet. | |
| • The raise/lower pad did not engage the lift motor. Hold down the | |
| pad for a couple of seconds to activate the motor. | |
| • The circuit breaker may have tripped. Check the circuit breaker— | |
| reset if necessary. | |
|
|
|
9
