GE dimensions ZVC42LSS GE Monogram 42 Custom Hood Insert, Custom Insert Liner, 3-11/16 1-11/16

ZVC42LSS

GE Monogram® 42" Custom Hood Insert

Custom Insert Liner	Dimensions and Specifications (in inches)
	Outside Dimensions

The custom canopy must be sized to fit the insert sleeve. Construct the canopy with an opening that is:

38-3/4"W x 13-3/16"D

The opening must be constructed of 3/4" thick material to allow the sleeve locking clips to engage.

The Insert Sleeve

The Supplied Liner

7/8”

7/8”

40-1/2”

A stainless steel liner is shipped with each hood insert. This non-combustible liner protects the underside of the canopy. Custom Liner

If you are not using the supplied liner, you may construct a custom non-combustible liner. Use the supplied liner as a template. The opening must be 38-3/4"W x 13-3/16"D. 3/4" thick material must surround the opening to allow the sleeve locking clips to engage. The insert sleeve inside the cabinet should be positioned 1/2" from the rear wall so that the center of the 8" duct is 5-1/2" from the rear wall.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

Remote Location for the Control

The control may be removed from the hood and installed into a wall or countertop. A 30-ft length of wire is supplied to accommodate most installations. A blanking plate covers the opening when the controls are removed. The overall size of the control is 4-1/4" wide and 2-1/4" deep.

3-11/16"

1-11/16"

We recommend that the cutout in granite or other hard surfaces be made before the countertop is installed.

Specification Created 9/08 130671