GE ZSC2202SS Assembly To Advantium Built-Inspeedcook Oven, ASSEMBLING THE OVEN TO DRAWER cont

ASSEMBLY TO ADVANTIUM BUILT-IN SPEEDCOOK OVEN

2UNDER-THE-COUNTER (UTC) MOUNTING BRACKET INSTALLATION

NOTE: For UTC models PSB1200, PSB1201 and ZSC1201 only.

AOpen the accessory drawer so you have access to the top bracket.

BRemove the three screws securing the top bracket.

CInstall the new UTC mounting bracket using the screws removed previously.

DClose the drawer and proceed with the installation.

3 ASSEMBLING THE OVEN TO DRAWER

APlace storage drawer on a surface with the front of drawer hanging over the edge of the surface. Not placing the front edge of drawer over the edge of the surface may result in damage to the drawer since the front edge of drawer hangs below the bottom of drawer.

BPlace the oven on top of the storage drawer. Make sure that the back and sides of the oven align with the back and sides of drawer.

NOTE: The bottom of the oven side flanges will sit directly in front of the top of the storage drawer side flanges.

ASSEMBLING THE OVEN TO DRAWER (cont.)

CRemove the front two bottom screws on each side of the oven and the top center screw on each side of the storage drawer.

DPlace the side supports into the tabs on the drawer and secure using the screws supplied and the screws removed in Step C.

Side

Support

120v only

EThe oven and storage drawer assembly is now ready to be installed. Return to the Advantium 120V or 240V Built-In SpeedCook Oven Installation Instructions to complete the installation.

Printed in Korea 2