GE Monogram dimensions ZBD3500ZWW-CleanSensor Dishwasher, Optional Kits, Created 6/98

Monogram.™

ZBD3500ZWW—CleanSensor Dishwasher

Dimensions and Specifications (in inches)

24"

Design Information: Designed for versatility, these dishwashers adapt to virtually any installation. This dishwasher is supplied as a white

4"

24 3/4"

Toekick

4 1/2"

34" Min.

35" Max.

25"

(Including 1/4"

Rear Insulation)

3 1/4"

model. Optional trim kits allow door and access panels to be replaced with custom panels of wood or other material to match cabinetry

or other appliances. GPF400S Trim Kit is also available for a stainless steel appearance.

To achieve a custom flush appearance, standard 24" base cabinets should be moved forward by use of spacer blocks.

Optional Kits:

•GPF425 Trim Kit-Provides for the installation of 1/4" thick custom door and access panels.

•GPF475 Trim Kit-Provides for the installation of 3/4" thick custom door and access panels.

•GPF400S Trim Kit-Provides stainless steel door and access panel.

•GPF400B, GPF400W Trim Kits-Black or White color change or replacement door and access panel.

•GPF600B, GPF600W Trim Kits-Black or White replacement door only.

•GPF700B, GPF700W Trim Kits-Black or White replacement access panel only.

•GPF100 Heavy Spring Kit-Heavy duty springs for door panels weighing 4 to 8 pounds. This spring kit is included with the GPF475 and GPF400S.

•GPF53 Mounting Kit-Special brackets for installing dishwasher beneath countertops of stone or other materials which will not accept screws.

Additional Specifications: A 120 Volt, 60 Hz power supply is required. An individual properly grounded branch circuit protected by a 15 or 20 amp circuit breaker or time delay fuse is recommended. Install a 3-prong electrical receptacle at least 6" above the floor and within 18" of the right or left adjacent cabinet wall. Wiring must enter the cutout in shaded area shown. A double, side-by-side installation requires two separate circuits.

The hot water line must enter the cutout in the shaded area from the right, left, rear or through the floor. The water line should be 3/8" O.D. copper or 1/2" O.D. plastic. Installation of an easily accessible hand shut-off valve is strongly recommended.

	This Wall Area
	must be Free of
34-1/2"±1/4"	Pipes or wires			24"
				Min.
Underside of	5"	4"	5"
				4"
Countertop
to Floor	Plumbing and Electric Services				Cabinets
	Must Enter Inside This Area
				6"	Square
					and Plumb
		24"
		Min.

The dishwasher should be placed no more than 10 feet from the sink for proper drainage.

For a corner installation, allow 2” clearance between dishwasher and adjacent cabinet or wall.

For answers to your GE Monogram,™ GE Profile,™

GE, Hotpoint and RCA appliance questions, call

GE Answer Center® service, 800.626.2000.

Listed by

Underwriters

RLaboratories

Created 6/98