Installation Instructions
STEP 2 LEVEL
•Use an adjustable wrench to turn the leveling legs and raise or lower the product.
•Adjust carefully; the product should be level and plumb with cabinetry, and should align with adjacent toekick height.
Turn Right to Lower
Turn Left to Raise
STEP 3 CONNECT POWER
•Connect power cord plug to a properly grounded receptacle.
•Check to make sure power is on by opening the door to see if interior light turns on.
STEP 4 SLIDE PRODUCT INTO
THE CUTOUT
WARNING: Do not apply pressure or push against the glass door when moving or installing these products. Pressure against the glass door will cause damage.
AVERTISSEMENT : Ne poussez
jamais et ne mettez jamais de pression sur la porte
en verre quand vous déplacez ou installez ces produits. Toute pression sur le verre occasionnera des dommages.
•Carefully slide the unit into the opening. Be careful not to entangle power cord.
•Make certain that the door protrudes 1″ beyond the surrounding cabinets.
•Check again to be sure the unit is level.
STEP 5 CHANGE THE TOEKICK
•The stainless steel toekick is secured to the back of the product or inside.
•The toekick has a cutout on the left
and right sides. Remove
the plug on
the left side and reinstall on the right side.
If you choose to install the stainless steel toekick,
reinstall the plug on the right side of that toekick.
•Install original screws and spacers or screws and spacers supplied with the stainless steel toekick. Install screws through the spacer standoff, toekick and into the base as shown.
STEP 6 SET TEMPERATURE
CONTROLS
•The temperature controls are preset. Refer to the Owner’s Manual for more information. Allow 24 hours for temperature to stabilize.
5
