ZDOD240PSS – GE Monogram Stainless Steel Outdoor/Indoor Refrigerator Module
Dimensions and Specifications (in inches) Installation Space
Product Clearances
Note: Handle and handle standoff depth is
Locate Outlet
| ||
9" | 24" Min. | |
Max. |
| |
| ||
| ||
(36"with | ||
top | ||
Including | canopy) | |
Handle |
|
24" |
Cabinet |
Wall |
110˚ |
15" Minimum
All models are factory set for a 110° door swing.
For a minimum 90° door swing:
• Allow
For a full 110° door swing:
Note: If installing between frameless cabinets, a 1/2" wide filler strip or side panel may be required. The filler strip will act as a spacer between the door case and adjacent cabinet and will prevent interference with cabinet door swing. The width of the opening must include filler panels.
Note: This product can be installed as a
The cutout depth must be 24"
The cutout dimensions shown allows for a full door swing and access to the
•The outdoor/indoor refrigerator can be used freestanding.
•Stainless steel top canopy can be removed for
•Vented stainless steel toekick.
Additional Specifications:
•A 120 volt 60Hz., 15 or 20 amp power supply is required.
An individual property grounded branch circuit or circuit breaker is recommended. Install a properly grounded
Warning:
This product must be connected to a power source with Ground Fault Circuit Interrupter (GFCI) protection when installed in an outdoor location.
Specification Revised 7/05
• Allow 15" min. clearance to wall on the hinge side.
Listed by
Underwriters
RLaboratories
For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at GEAppliances.com or call GE Answer Center® service, 800.626.2000.
120028