GE Monogram ZISS480NXSS dimensions Dimensions and Installation Information in inches

*84" From Floor to Top Frame

ZISS480NXSS

GE Monogram® 48" Built-In Stainless Steel Side-by-Side Refrigerator with Automatic Icemaker and Water Filter

Dimensions and Installation Information (in inches) The Installation Space

47"

Case Width 25-3/4"

*83-1/2" at Rear

27-3/4"	48"
	Frame to Frame
including
handle

*Shipping height. The refrigerator can be adjusted to fit into a cutout that is 83-1/2" min. to

84-1/2” max. height. Note that the top case trim at the front is 1/2" higher and will overlap upper cabinetry or soffit. Use leveling legs and wheels for a maximum 1" height adjustment.

35-1/2" for 36" models						36" Models 12"
41-1/2" for 42" models						42" Models 18"
47-1/2" for 48" models						48" Models 20"
	*Finished		Width
	6"
84-1/2" max	Electrical
				5"
83-1/2" min	Area
Finished						75" From Floor
Opening
						to Bottom
	24"					of Electrical
							Area
	5"	Water Supply			5"	3-1/2"

Product Clearances

These refrigerators are equipped with a 2 position door stop. The factory set 130° door swing can be adjusted to 90° if clearance to adjacent cabinets or walls is restricted.

3-1/2"

Water and electrical locations

The opening must be prepared with the electrical and water supply located as shown.

130° Door Swing

15"

20"

90° Door Swing

23-7/8" Behind Frame

28-5/8"

4" Min. to Wall

The cutout depth must be 24".

The refrigerator will project forward, slightly beyond adjacent cabinetry, depending on your installation.

The cutout depth beneath a soffit:

When installed beneath a soffit, the soffit cannot exceed the 24" installation depth shown. The top case trim overlaps the bottom of the soffit.

Frameless cabinets:

The case trim overlaps cabinets at the top and sides. Therefore, frameless cabinets may require filler strips to

Allow minimum clearances for freezer door and fresh food door for a full 130° door swing and to allow for pan removal.

4" minimum clearance is required when door swing is adjusted to 90°. If the 90° door stop position is used, pan access is maintained, but pan removal is restricted.

Installation Information: Before installing, consult installation instructions packed with product, or online at Monogram.com, for current dimensional data.

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

prevent interference with cabinet door swing. The opening must allow for filler strips.

Additional Specifications

•A 115 volt 60Hz., 15 or 20 amp power supply is required. An individual properly grounded branch circuit or circuit breaker is recommended. Install a properly grounded 3- prong electrical receptacle recessed into the back wall. Electrical must be located on rear wall as shown.

Note: GFI (ground fault interrupter) is not recommended.

•Water line can enter the opening through the floor or back wall. The water line should be 1/4" O.D. copper tubing or GE SmartConnect™ kit between the cold water line and water connection location, long enough to extend to the front of the refrigerator. Installation of an easily accessible shut off valve in the water line is recommended.

Listed by

Underwriters

Laboratories

Specification Revised 11/08 110192