Geemarc CLA 7 manual Connecting, Making And Receiving Calls

(*) Classified TNV-3 according to EN60950 standard.

2 - CONNECTING

-Open the battery compartment.

-Insert 2 AAA 1.5V type alkaline batteries without mercury, making sure the polarity is according to the diagram in the battery compartment.

-Replace the battery cover.

Now, the CLA 7 is ready to use.

Note :

-Always disconnect the plug of the CLA7 from the telephone before installing the batteries.

-Do not dispose of batteries in household rubbish. Pay attention to the battery regulations regarding battery disposal.

3 - MAKING AND RECEIVING CALLS

-Place the loop around your neck.

-Connect the plug to the headset socket of your telephone(*).

(see the instruction manual of your telephone - if you have a problem locating the socket).

-Switch your hearing aid to T mode.

-Now you are ready to speak through your CLA 7. Press the ON/OFF button.

The green light will turn on.

-During the call, you can adjust the volume of the device by using the volume control knob located on the bottom of the CLA 7.

-On completion of the call, press the ON/OFF button.

The green light turn off.

Do not forget to turn OFF your CLA 7 at the end of the call. Failure to do this will drain the batteries after about 30 hours. Please consult your dealer for details of our high capacity rechargeable batteries and rapid battery charger. In the unlikely event that your dealer does not stock this item, please visit our website www.geemarc.com or call our HOTLINE 01707 38 44 38

3