INTRODUCTION:
Congratulations on purchasing the Gemini
FEATURES:
-Audio CD,
-
-2 Selectable Jog modes Pitch Bend/Search
-
-Single
-One seamless loop per side with reloop
-Pitch bend via jog wheel or buttons
-Three mode time selection
-Frame accurate search
-Large blue backlit LCD display
-Coaxial RCA digital output
-Rubber jog wheels with finger grips
-Variable pitch control with a 16% range
SAFETY SPECIFICATIONS:
Laser Diode Properties
Material: Ga - Al - As
Wavelength: 755 - 815 nm (25° C)
Laser Output: Continuous Wave, max. 0.5 mW
PRECAUTIONS:
1.Do not use this CD player at temperatures below 41°F/5°C or higher than 95°F/35°C.
2.The apparatus should not be exposed to dripping or splashing, and no objects filled with liquids such as vases should be placed on the apparatus.
3.Place the unit in a clean and dry location.
4.Do not place the unit in an unstable location.
5.When disconnecting the power cord from the AC outlet, always grasp it by the plug. Never pull the power cord.
6.To prevent electric shock, do not remove the cover or the bottom screws.
7.There are NO USER SERVICEABLE PARTS INSIDE. Please refer to a qualified technician.
IN THE USA ~ IF YOU EXPERIENCE PROBLEMS WITH THIS UNIT CALL GEMINI
CUSTOMER SERVICE AT:1 (732)
TO YOUR DEALER.
8.Do not use chemical solvents to clean the unit.
9.Keep the laser pickup clean by keeping the tray closed.
10.Keep this manual in a safe place for future reference.
CONNECTIONS:
1VOLTAGE SELECTION SWITCH Before plugging the
To change this selection unscrew the hard plastic protective top with a Phillips head screw driver. Then use a flat head screw driver to move the switch to the proper selection (115V or 230V) .
Do not force or twist the switch. Excessive force may cause damage, if the switch does not move smoothly, contact a qualified technician.
2POWER After you have properly set the VOLTAGELINE SELECTOR SWITCH you may plug in the power cord of the
3LINE OUTPUT JACKS Plug one end of the included RCA cable into LINE OUTPUT JACKS on the rear panel. Plug the other end of the RCA connectors into any available line input jacks on your mixer.
If you are connecting the
4CONTROL CABLES Plug the CONTROL CABLES to each side of the
FUNCTIONS:
5POWER: Once you have connected all your cables and made sure that the VOLTAGE SELECTION SWITCH is set correctly, you can turn the
6DISC TRAY: The DISC TRAY is where the CD is held during loading, unloading and playback, and holds both 12 cm and 8cm CD’s.
(DO NOT FORCE THE CD TRAY TO CLOSE EXCESSIVE FORCE WILL
DAMAGE THE CD MECHANISM, USE THE OPEN AND CLOSE BUT- TONS)
7EJECT BUTTON: Pressing the EJECT BUTTON will open or close the DISC TRAY,unless the
8JOG WHEEL : In SEARCH MODE the JOG WHEEL can be used to search forward or bacwards in the music track, as well as for fine adjustments to a CUE point in PAUSE mode. In PITCH BEND mode the JOG WHEEL will function the same as the PITCH BEND allowing you to speed up (FORWARD) or slow down (REWIND) the music clock- wise bieng (FORWARD) and counter clockwise being (REWIND).
9JOG MODE BUTTON: When the JOG MODE BUTTON is illuminated it indicates the the JOG WHEEL is in SEARCH MODE, and when not illuminated it indicates that the JOG WHEEL is in PITCH BEND MODE.
10DISPLAY: The DISPLAY shows the track number, pitch value, pitch bend, single, continue (for continuous play), play/pause modes, fast forward/reverse modes, loop mode, reloop mode, PGM, repeat modes, the playback display bar, and three diffirent time displays. These times displays are TIME ELAPSED on the track, TIME REMAIN- ING on the disc and and TIME REMAINING on the track. Time is measured in minutes, seconds and frames.
11PGM: Allows you to create a set playlist. To program a set list into the
12REPEAT: Press the repeat button once to engage 1 or repeat the selected track. Press REPEAT again to engage ALL setting wich will repeat all the tracks on the CD. Press REPEAT again to disengage the repeat function
4