PM-100
Speaker System
Introduction
Congratulations on purchasing the Gemini
Features
•ABS plastic construction
•Separate bass, treble and volume controls
•Surround enhancement (3D Function)
•All necessary cables
Cautions
1.Read all operating instructions before using this equipment. Keep this manual in a safe place for future reference.
2.The apparatus should not be exposed to dripping or splashing and no objects filled with liquids such as vases should be placed on the apparatus.
3.To reduce the risk of electrical shock, do not open the unit. There are NO USER REPLACEABLE PARTS INSIDE. Please contact the Gemini Service Department or your authorized dealer to speak to a qualified service technician.
4.Be sure that all AC power is OFF while making connections.
5.Do not expose this unit to direct sunlight or to a heat source such as a radiator or stove.
6.This unit should be cleaned only with a damp cloth. Avoid solvents or other cleaning detergents.
7.When moving this equipment, it should be placed in its original carton and packaging. This will reduce the risk of damage during transit.
8.DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. Operators of electronic equipment should in no way be in contact with water.
9.DO NOT USE ANY SPRAY CLEANER OR LUBRICANT ON ANY CONTROLS OR SWITCHES.
10.If any objects or liquid fall into the unit, turn off the power and unplug the unit immediately and have the system checked by a qualified service technician before using it again.
Connections
1.Make sure that the power switch located on the front of the right speaker is in the OFF position. This unit comes supplied with a DC power adaptor. Plug the adaptor into the power jack (located on the bottom rear of the right speaker). Then plug the adaptor into a proper power source.
2.Plug the cord coming from the left speaker into the connector marked L- SPK on the right speaker.
3.Plug one end of the RCA cables into the output jacks on your mixer. Plug the other end of the RCA cables into the jacks on the back of the right speaker marked INPUT. When you are connecting the RCA cables, make sure to match the color on the cable to the color on the speaker connector (white = left channel, red = right channel).
4.Use the jack on the back of the right speaker marked OUTPUT to connect to a subwoofer (optional).
Operation
1.Turn all of the controls (bass, treble and volume) located on the front of the right speaker all the way to the left (the lowest level).
2.Press the power switch located on the front of the right speaker to the ON position (the LED will light).
3.Adjust the bass, treble and volume controls to the desired levels.
4.For an enhanced effect, press the 3D button (located on the front of the right speaker) to the ON position to add a 3 dimensional spacial effect to your program.
Specifications
Output Power | 25W + 25W WMRS | |
PMPO | 300W | |
Speaker Unit | 1.5” treble, 4” bass (magnetically shielded) | |
Impedance | 4 Ohm | |
Frequency Response | 60 Hz - 18 kHz | |
Input Connectors | RCA jacks | |
Output Connector | 3.5 mm stereo phone jack | |
Treble Up | 10 dB ± 2 | dB |
Bass Up | 10 dB ± 2 dB | |
Separation | 48 | dB |
S/N Ratio | 75 | dB |
Dimensions | 7” x 5” x 10” (180 x 124 x 251 mm) | |
Weight | 5.5 lbs (2.5 kg) | |
Page 2
