Introduction
Operation
Congratulations on choosing a Gemini power amplifier. This state of the art amplifier includes the latest features and is backed by a three year warranty. Prior to use, please read all of the instructions.
Features
•Continuous Advanced Protection circuitry
•Bridge to Mono capable
•Fan Cooled
•One Switched & One Unswitched Rear Panel AC Outlets
•Supports Two Sets of Speakers
•Supports Balanced & Unbalanced Inputs
Cautions
1.All operating instructions should be read before using this equipment.
2.To reduce the risk of electrical shock, do not open the unit. There are NO USER REPLACEABLE PARTS INSIDE. Please refer servicing to a qualified service technician.
3.Do not expose this unit to direct sunlight or to a heat source such as a radiator or stove.
4.This unit should be cleaned only with a damp cloth. Avoid solvents or other cleaning detergents.
5.When moving this equipment, it should be placed in its original carton and packaging. This will reduce the risk of damage during transit.
6.DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
7.DO NOT USE ANY SPRAY CLEANER OR LUBRICANT ON ANY CONTROLS OR SWITCHES.
Connection
1.Be sure that POWER (1) is in the OFF position. All connections must be made with all equipment OFF.
2.Before plugging in the power cord, make sure the VOLTAGE SELECTOR SWITCH (14) is set to the correct voltage.
3.For best sound use only high quality audio cables for your hook up. Make sure all cables are pushed in securely.
4.Use the LINE IN (11) jacks to attach your input signal to the
5.The
6.A GND TERMINAL (9) is provided for grounding the
7.Make sure that the FAN (10) is not obstructed.
1.POWER ON: Once you have made all source connections to your
2.PROTECTION LED: The PROTECTION LED (3) illuminates RED when the amplifier overheats or when a shorted load or DC is detected on the amplifier output. The amplifier will reset itself when the problem is corrected.
Note: When you first turn on the power, the PROTECTION LED will illuminate for a few seconds. This is normal.
3.SPEAKER SELECTION: The
4.VOLUME CONTROL: You can easily control the output level to your speakers (the volume) by using the rotary VOLUME CONTROLS (5, 6). VOLUME CONTROL (5) adjusts the left channel and VOLUME CONTROL (6) adjusts the right channel. The
WARNING: If the CLIP LEDs (8) remain on steadily, cut the levels down or the unit will go into protection.
Specifications
Momentary MusicPeak Power........................................1280 watts
Maximum Power Output (RMS) at 1 kHz....640 watts 8 Ω Bridged Mono
|
| 320 watts at 4 Ω |
|
| 200 watts at 8 Ω |
Distortion | less than 0.08% at rated power output into 8 Ω | |
Frequency Response | 20 Hz to 60 kHz | |
Signal To Noise Ratio | 98 dB | |
Output Section | 4 - 16 Ω | |
Indicators | Output Signal, Power & Protection | |
Power Consumption | 1280 watts (Max) | |
Dimensions | 19 “ x 4 3/8 “ x 10 1/2 “ | |
Weight | 21.6 lbs | |
Rack | 2.5 U rack spaces |
Page 3