a b s o l u t e f i d e l i t y
balanced input of the servo amplifier. Do not use any other interconnection for this purpose! This internal circuit also allows even fully balanced power amplifiers to be connected this way.
Plug the banana plug end of these interconnects into the binding posts of your midrange/tweeter towers (preferred) or the output binding posts of your power amp. Each end of the interconnect has a grounding alligator clip on a flying orange lead. Leave this grounding clip disconnected for the time being.
The second way to connect the
Connect the input of the woofer amplifier to the output of your preamplifier. Choose either balanced or unbalanced for inputs. If your preamplifier has only one set of balanced outputs and one set of unbalanced (RCA) type outputs, choose your first preference of connection for the power amplifier that is driving the midrange tweeter panels of your speaker. Use the remaining set of outputs to feed the woofer amplifier. If your preamplifier has only one set of outputs, you will need a
As no power amplifier is “straight wire with gain”, we do not recommend this way of driving your
Control Adjustments
Plug the woofer amplifier into a power outlet, and using the remote control, turn it on by pressing the POWER button. If that does not work, press the MODE button and make sure that the led above that button flashes red.
Use the buttons marked “VOL ” or “VOL ” to adjust the volume to 20 to start with. (Again, if you are not driving the
7
