~ Ä ë ç ä ì í É = Ñ á Ç É ä á í ó ™
using your G928 this way, place it just behind and to the outside of your existing loudspeakers. (The right one if you have only one G928)
If you are using the G928 for a home theater LFE channel, place it about one-third of the way in-between your main left and right speakers.
Adjusting the Controls
For music, find the spec sheet of your existing main loudspeakers, and adjust the Low Pass frequency to the –3dB point (if you can’t find that, set it to 63Hz – the 12 o’clock position on the knob). For speakers of general sensitivity, the Bass Gain and LFE Gain can also be set at the 12 o’clock position.
Note: Should your woofer amplifier unexpectedly turn off and you are unable to turn it back on, you may have overheated or over-driven the amplifier. It will take up to thirty minutes for the amplifier to turn back on. Be patient. The causes for this are poor ventilation and too much volume. If the amplifier is well ventilated then you have the volume control turned up to high. Refer to the section on increasing the low frequency response of your speakers without turning up the volume control.
4
