HEADPHONE JACK - This jack, located on the rear panel, allows the user to enjoy the tone of this amp through standard headphones
EFFECTS CANCEL JACK - A ¼” effects cancel jack is provided on the back panel to mute the internal effects via foot- switch. Any standard single button latching footswitch (with shielded cable) may be used. Signal is muted when the switch is closed.
POWER AMPLIFIER - The Shenandoah® Stereo 80LT contains an advanced stereo monolithic power amplifier circuit that is completely protected against overloads, short circuits and thermal faults. Output is rated at 40 watts per side (80 watts total) into 4 ohms, with excellent overload recovery characteristics.
IEC POWER INLET CONNECTOR - The Shenandoah® Stereo 80LT uses a detachable power cord and
is shipped from the factory with the appropriate power inlet cable and connector for the market the amplifier was shipped to. There is an AC mains fuse located in a small drawer within this molded connector.
PHANTOM POWER - An internal phantom power source (12 volts) is provided for use with condenser mics.
This power source is on at all times and does not affect the standard operation of the amp, even when a condenser mic is not used. We use the DIN
be compatible and will require 48 volt phantom power. We suggested live sound condenser mics by: AKG, Audio Tech- nica, Shure and Crown.
SPEAKER OUTPUT JACK - The Shenandoah® Stereo 80LT provides left and right ¼” speaker output jacks. Minimum total load is 4 ohms per side.
SPEAKER COMPLIMENT - The Shenandoah® Stereo 80LT utilizes two specially designed 6.5” woofers and dual compression tweeters. The cabinet features a front port for more rounded low frequency response. The impedance of the internal speakers is 4 ohms per side.
MONITOR SHAPED CABINET DESIGN - The Shenandoah® Stereo 80LT utilizes lightweight plywood to help reduce weight. This cabinet design offers two platforms so the cabinet can be used in the normal upright position or tipped back towards the performer for more of a monitoring situation. Leaning the cabinet back can change the tone of the amp and reduce boomy low frequencies.
SPEAKER STAND MOUNT - A 1 1/2” speaker stand mount is provided for use with a speaker stand.
WARNING!
•The use and operation of this device constitutes an agreement of full release of any and all liability connected with its use. Only persons familiar with the operation of high powered audio equipment should attempt to operate this device.
•In addition, by use of this device, the user agrees to hold Genz Benz and its designers, sales agents, and all other affiliates and related parties harmless in the event of any accident, injury, damage, or loss resulting from such use.
•Manufacturer’s sole responsibility is to provide a warranty on the specified performance of the product under normal operating conditions for a period of 3 years.
