How To Use the

George Foreman Open Hearth Grill

WARNING: Charcoal or similar combustible fuels must not be used with this appliance.

1.Before using the Grill for the first time, remove the protective film from the Grill Plate. Wash the Drip Tray and Grill Plate in warm soapy water. See User Maintenance Instructions.

2.Place the Drip Tray into the Grill Base.

3.Place the Grill Plate on the Drip Tray.

NOTE: Drip Tray and Grill Base

Slot

MUST always be in place when

Rib

using the Grill.

 

4. Attach the Splatter Guard to the Grill by positioning the Splatter Guard on the Grill Plate so that the slots in the Guard are resting securely over the ribs at either end of the Grill Plate, as

shown in Figure 1. The Splatter

Guard simply lifts off for easy cleaningFigure 1 and storage.

5.Turn the Temperature Control Probe to "OFF", insert it fully into the recep- tacle on the Grill Plate. Plug the cord into a 120V AC electrical outlet.

6.To preheat: Turn the Temperature Control Probe dial to the desired heat setting, or the heat setting recommended in the recipe/Grilling Chart. The Thermostat Light will illuminate. Note: The Thermostat Light on the Temperature Control Probe indicates the Grill is heating. The light will remain ON until the set temperature has been reached and then will cycle ON and OFF as needed to maintain the set temperature.

7.Allow the Grill to preheat except where noted on the Grilling Chart. The preheat time will depend on the heat setting selected. If a high heat set- ting is selected, a longer preheat time is required.

8.Carefully place the items to be cooked on the Grill Plate and allow the food to cook until done. (Consult the Recipe Section/Grilling Chart in this book.) Do not leave Grill unattended during use!

9.When finished cooking, turn the Temperature Control Probe to "OFF". Disconnect the plug from the wall outlet and let the Grill cool completely.

10.Remove the food using a heat resistant plastic or wooden utensil. Be sure to always use either plastic or wooden utensils so as not to scratch the non-stick surface. Never use metal tongs, forks or knives as these can damage the coating on the Grill Plate.

11.When cool, the Drip Tray may be removed and emptied. Be sure the liq- uid has cooled before removing Drip Tray.

7