Gianni Industries BTS-486 specifications BTS Touch Sensitive Switch Installation Instruction

BTS Touch Sensitive Switch

Installation Instruction

Specifications

Specifications		Setting JP
	SPDT relay rating: 3A@ 125V~	1
		2
	Current: 60mA~100mA@12V DC	3
		4
	Power input :12~24 V DC	5

BTS-486

1 30

Relay output		Relay output
Com.	N. C. (Touched)	Com.	N. O.
Relay output		Relay output
Com.	N. O. (Touched)	Com.	N. C.

Operating Temper.: - 20~+70ºC JP setting:

JP1: Relay output model

JP2: LED lighting or blinking setting

Jp3~5: LED brightness setting

Relay

(Light is lighting)

(Light is blinking.)

(Green) (Touched)

(Red)

BTS-300 , 400-ANSI

(Red) (Green)

(Touched)

Relay contact output (free voltage contact)

12~24VDC power input

Relay

(Green) (Touched)

(Green)

Relay output model

control and LED

brightness setting

Setting JP

Timer delay (Seconds)

1 30

(Touched)

(Red) (Touched)

(Touched)

(Red)

Connecting Diagram

BTS-200 adds an extra		Control Device(Outdoor)		Fig. A
trigger for remote control			N.C.
purpose; it has the same
		Relay output	Com.
effect as touching motion.		control	N.O.
T h e d i a g r a m s b e l o w i l l u s t r a t e t h e t w o
recommended ways of installing the BTS Touch	(Trigger)		TR
Sensitive Switch and access control devices after			TR
power input (power on).			N.C.	Locking Device
			Com.	(fail-safe)
	Power Supply
		Shorten N.O.
In Fig. A, BTS directly controls the release of fail-
safe(Power to Lock) locking device.
		BTS Touch Sensitive Switch
		(Indoor)
BTS-200 adds an extra		Control Device(Outdoor)		Fig. B
trigger for remote control			N.C.
purpose; it has the same
		Relay output	Com.
effect as touching motion.		control	N.O.
In Fig. B, For fail-secure(Power to Unlock) locking	(Trigger)		TR
devices the contact on control device should be sat			TR
to N.O. The relay time of BTS is the same as the			N.C.	Locking Device
release time of locking device in both cases.
			Com.	(fail-secure)
	Power Supply
		Shorten N.O.
		BTS Touch Sensitive Switch
		(Indoor)

IMPORTANT NOTICE:

1.It is important to take extra notice on the maximum voltage and current output that the rated of relay contact to be used.

2.Make sure that the "+" and "-" wire are connected correctly.

Copyright © 2008 GIANNI INDUSTRIES, INC. All rights reserved.

P-MU-BTS200 Ver. L Published on 2008.06.09