Specifications
Model GP7155A, GP7255A
................................................................ | U.S | Metric |
Volume | 65.8 GPM | 250 LPM |
Discharge Pressure | 1500 PSI | 100 Bar |
Speed | 2000 PSI | 138 Bar |
Inlet Pressure | Up to 700 RPM | |
Plunger Diameter | 2.17” | 55mm |
Plunger Stroke | 2.05” | 52mm |
Crankshaft Diameter | 1.89” | 48mm |
Key Width | 0.55” | 14mm |
Crankshaft Mounting | Either side | |
Shaft Rotation | Top of pulley towards manifold | |
Max.Temperature of Pumped Fluids | 140 oF | 60 oC |
Inlet Ports | (2) | |
Discharge Ports | (2) | |
Weight | 374 lbs | 170 kg |
Crankcase Oil Capacity | 1.6 Gal | 6.0 liters |
Fluid End Material GP7155A | Bronze | |
Fluid End Material GP7255A | Nickle Plated Spheroidical Cast Iron | |
Mechanical Effecency @ 700 RPM | 0.83 | |
Volumetric Effecency @ 700 RPM | 0.96 |
Consult the factory for special requirements that must be met if the pump is to operate beyond one or more of the limits specified above.
PULLEY INFORMATION
Pulley selection and pump speed are based on a 1725 RPM motor and "B" section belts. When selecting desired GPM, allow for a ±5% tolerance on pumps output due to variations in pulleys, belts and motors among manufacturers.
1.Select GPM required, then select appropriate motor and pump pulley from the same line.
2.The desired pressure is achieved by selecting the correct nozzle size that corresponds with the pump GPM.
HORSEPOWER INFORMATION Horsepower ratings shown are the power require- ments for the pump. Gas engine power outputs must be approximately twice the pump power require- ments shown above.
We recommend that a 1.1 service factor be specified when selecting an electric motor as the power source. To compute specific pump horsepower requirements, use the following formula:
(GPH X PSI) / 1450 = HP
GP7155A, GP7255A PULLEY SELECTION & HORSEPOWER
REQUIREMENTS
PUMP | MOTOR | RPM | GPM | 800 PSI | 1000 PSI | 1300 PSI | 1500 PSI | 2000 PSI |
PULLEY | PULLEY | |||||||
12.75 | 9.00 | 479 | 45.0 | 25.7 | 32.1 | 41.8 | 48.2 | 64.3 |
12.75 | 9.75 | 531 | 49.9 | 28.5 | 35.6 | 46.3 | 53.5 | 71.3 |
12.75 | 10.75 | 585 | 55.0 | 31.4 | 39.3 | 51.1 | 58.9 | 78.6 |
12.75 | 11.70 | 638 | 60.0 | 34.3 | 42.9 | 55.7 | 64.3 | 85.7 |
12.75 | 12.75 | 700 | 65.8 | 37.6 | 47.0 | 61.1 | 70.5 | 94.0 |
3