Gigabyte 7VM333M-RZ user manual Fpanel 2 x 10 pins Connector, Faudio FrontAudio Connector

7) F_PANEL (2 x 10 pins Connector)

Please connect the power LED, PC speaker, reset switch and power switch etc. of your chassis front panel to the F_PANEL connector according to the pin assignment below.

Me ssa ge LED/Powe r/	So ft Pow er
Sle ep L ED	Conne ctor	Spe aker C onnector

		MSG+		PW+
								SPEAK+	SPEAK-
		-
			MSG			PW-
	1			1				1		20
	2
	1 1								19
							1
		HD+ HD- RES- RES+ NC
	ID E H ar d D i sk				Re set Switch
	Acti ve L ED
HD (IDE Hard Disk Active LED)		Pin 1: LED anode(+)
		Pin 2: LED cathode(-)
SPK(Speaker Connector)		Pin 1: VCC(+)
		Pin 2- Pin 3: NC
		Pin 4: Data(-)
RES (Reset Switch)		Open:Normal Operation
		Close: Reset Hardware System
PW (Soft Power Connector)		Open:Normal Operation
		Close:Power O n/Off
MSG (Message LED/ Power/ Sleep LED)		Pin 1: LED anode(+)
		Pin 2: LED cathode(-)
NC		NC

8) F_AUDIO (FrontAudio Connector)

If you want to use FrontAudio connector, you must remove 5-6, 9-10 Jumper.

In order to utilize the front audio header, your chassis must have front audio connector. Also please make sure the pin assigment on the cable is the same as the pin assigment on the MB header. To find out if the chassis you are buying support front audio connector, please contact your dealer. Please note,

you can have the alternative of using front audio connector or of using rear audio connector to play
sound.
			Pin No.	Definition
1	2		1	MIC
		2		GND
		3		REF
			4	Power
9	1 0		5	FrontAudio (R)
			6	Rear Audio (R)
			7	Reserved
			8	No Pin
			9	FrontAudio (L)
		10		Rear Audio (L)

English

- 15 - Hardware Installation Process